Hi! Am 14.12.2011 um 10:26 schrieb Jeremy Chadwick: >> What is the proper equivalent for ahci, ada0 and camcontrol? > > None is needed: yank the disk, reinsert, wait a few seconds, done. > Validation, with full output, hardware, etc: > > http://koitsu.wordpress.com/2010/07/22/freebsd-and-zfs-hot-swapping-sata-disks-with-ahci/
Yank the disk: (ada0:ahcich0:0:0:0): lost device Reinsert - nothing happens. >> shutdown -r now >> -> system panics, eventually reboots > > Before you yanked the disk, were any non-ZFS filesystems mounted? Yes - my fault. I had an active swap partition on the disk which perfectly explains the panic. > You might try booting RELENG_9 (which has ahci.ko as the default, so no > need to mess about) on a LiveCD or equivalent and attempt the same > thing. I'm left wondering if there's some stuff in RELENG_8 (not a typo > compared to the above RELENG_9 reference) that you do not have in > RELENG_8_2. I'll try upgrading to RELENG_8 first and report the results. Side note: ada0: 150.000MB/s transfers (SATA 1.x, UDMA6, PIO 8192bytes) I noticed that while preparing the last mail and removed those little jumpers limiting my hard drives ;-) Thanks, Patrick -- punkt.de GmbH * Kaiserallee 13a * 76133 Karlsruhe Tel. 0721 9109 0 * Fax 0721 9109 100 [email protected] http://www.punkt.de Gf: Jürgen Egeling AG Mannheim 108285 _______________________________________________ [email protected] mailing list http://lists.freebsd.org/mailman/listinfo/freebsd-stable To unsubscribe, send any mail to "[email protected]"
