Hello
I'm trying to add a new disk to my system via /stand/sysinstall, but as
soon as I get started the following message pops us"
"No disks found! ..."
I have only SCSI disks in this server and am running 4.1-stable. Below are
the applicable portions from dmesg. The new disk is da1. Any help would be
most appreciated.
Thanks
Antonio
-----------------------------------------------------------------------------
FreeBSD 4.1-STABLE #5: Mon Aug 14 12:35:57 EDT 2000
[...]
ahc0: <Adaptec aic7890/91 Ultra2 SCSI adapter> port 0xd000-0xd0ff mem
0xe1000000-0xe1000fff irq 10 at device 6.0 on pci0
ahc0: aic7890/91 Wide Channel A, SCSI Id=7, 16/255 SCBs
ahc1: <Adaptec 2940 Ultra2 SCSI adapter> port 0xb800-0xb8ff mem
0xe0800000-0xe0800fff irq 10 at device 9.0 on pci0
ahc1: aic7890/91 Wide Channel A, SCSI Id=7, 16/255 SCBs
[...]
da3 at ahc0 bus 0 target 5 lun 0
da3: <IOMEGA ZIP 100 J.03> Removable Direct Access SCSI-2 device
da3: 3.300MB/s transfers
da3: 96MB (196608 512 byte sectors: 64H 32S/T 96C)
da0 at ahc1 bus 0 target 0 lun 0
da0: <QUANTUM VIKING II 4.5WLS 5520> Fixed Direct Access SCSI-2 device
da0: 40.000MB/s transfers (20.000MHz, offset 31, 16bit), Tagged Queueing Enabled
da0: 4350MB (8910423 512 byte sectors: 255H 63S/T 554C)
da2 at ahc1 bus 0 target 3 lun 0
da2: <SEAGATE ST39173W 6244> Fixed Direct Access SCSI-2 device
da2: 40.000MB/s transfers (20.000MHz, offset 15, 16bit), Tagged Queueing Enabled
da2: 8683MB (17783240 512 byte sectors: 255H 63S/T 1106C)
Mounting root from ufs:/dev/da0s1a
da1 at ahc0 bus 0 target 1 lun 0
da1: <SEAGATE ST118273W 6244> Fixed Direct Access SCSI-2 device
da1: 40.000MB/s transfers (20.000MHz, offset 15, 16bit), Tagged Queueing Enabled
da1: 17366MB (35566480 512 byte sectors: 255H 63S/T 2213C)
To Unsubscribe: send mail to [EMAIL PROTECTED]
with "unsubscribe freebsd-stable" in the body of the message
