[ On Friday, October 6, Sean O'Connell wrote: ] > > John- > > Have you included Soren Schmidt ([EMAIL PROTECTED]) on this thread? He No, I haven't explicitly. I was hoping to go sleuthing around the code a bit and have a general idea of where he should look before I bugged him directly. > is the maintainer/developer of the ATA stuff. Also, what ata stuff > do you have in your kernel? Do you do the full-blown, > > device ata0 at blah > device ata1 at blah > > or do you use the > > device ata > > and let the chips fall? I copied this kernel config from GENERIC and then edited appropriately. So, yes, I do have the "blah" as above, but you'll notice that "device ata1" is definitely commented out (and has been "forever") since I don't have anything there. # ATA and ATAPI devices device ata0 at isa? port IO_WD1 irq 14 #device ata1 at isa? port IO_WD2 irq 15 device ata device atadisk # ATA disk drives device atapicd # ATAPI CDROM drives device atapifd # ATAPI floppy drives device atapist # ATAPI tape drives options ATA_STATIC_ID #Static device numbering #options ATA_ENABLE_ATAPI_DMA #Enable DMA on ATAPI devices -Jr -- =-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-= | John Reynolds WCCG, CCE, Higher Levels of Abstraction | | Intel Corporation MS: CH6-210 Phone: 480-554-9092 pgr: 602-868-6512 | | [EMAIL PROTECTED] http://www-aec.ch.intel.com/~jreynold/ | =-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-= To Unsubscribe: send mail to [EMAIL PROTECTED] with "unsubscribe freebsd-stable" in the body of the message
