This is the information which is provided by freebsd 4.6 (and it doesn't seem to matter if I use -v flag or not) :
Fatal trap 12: page fault while in kernel mode fault virtual address = 0x230 fault code = supervisor read, page not present instruction pointer = 0x8:0xc0168d52 stack pointer = 0x10:0xc037e73c frame pointer = 0x10:0xc037e74c code segment = base 0x0, limit 0xffffff, type 0x1b = dpl 0, pres 1, def32 1, gran 1 proc flags = interrupt enabled, resume, IOPL=0 current process = Idle Interrupt mask = 12 panic : page fault hope this is information is satisfying..:) Hans >From: "Justin T. Gibbs" <[EMAIL PROTECTED]> >To: "Hans Eichbaum" <[EMAIL PROTECTED]> >CC: [EMAIL PROTECTED] >Subject: Re: ahc_intr - referenced scb not valid during SELTO scb (0,139) >Date: Fri, 28 Jun 2002 14:06:21 -0600 > > >Hi there, > > > >I've a problems installing FreeBSD on a compaq deskpro machine. During > >install, just when booting the system from cd-rom I get the folowing >message > >after 15 seconds of initializing the scsi devices > > > >ahc0 : ahc_intr - referenced scb not valid during SELTO scb (0,139) > >Hmm. Its hard to say why this is happening without more information. >Can you provide the probe information that FreeBSD outputs for this >controller while booting "-v"? > >-- >Justin _________________________________________________________________ Join the world�s largest e-mail service with MSN Hotmail. http://www.hotmail.com To Unsubscribe: send mail to [EMAIL PROTECTED] with "unsubscribe freebsd-stable" in the body of the message
