no, i use the same cable, now i disconnect the drive ( ad2 ) and get the same errors for ad1. ad1 is on the primary controller. ad2 was on the secondary controller. ad1 is a brand new drive.
regards Stefan On 23 Nov 2003 17:13:47 -0500 Lowell Gilbert <[EMAIL PROTECTED]> wrote: > Stefan Knoblauch <[EMAIL PROTECTED]> writes: > > > after upgrading from 4.8 to 4.9 i got mane "hard error reading fsbn" > > errors. ok i thougt that is a problem of the 2 years old 80 GB > > harddisk so i get a new 80 GB drive. after restoring the system to > > to the new drive, i get the same errors. the next step was to reformat > > the disk on a windows box. this works fine and the harddisk lokks > > good. i put the disk into my freebsd 4.9 system and do not have this > > read errors. after 1 week re errors come back. more than before. > > i do not have any errors with the 4.8 version, so i make a complete > > new installation with 4.9. yaeh, no errors. one week later the > > systemlog shows me the errors again. in my ear's the system is not > > stable. i use 1 maxtor and one IBM disk. does anyone know what the > > problem is ? > > No, but did you replace the drive cable > when you replaced the drive itself? _______________________________________________ [EMAIL PROTECTED] mailing list http://lists.freebsd.org/mailman/listinfo/freebsd-stable To unsubscribe, send any mail to "[EMAIL PROTECTED]"
