RELENG_4 On Sat, 2004-03-27 at 19:07, Julian Elischer wrote: > Michael E. Mercer wrote: > > Julian, > > > > I am running 4.9-Stable. I do not see EHCI in the LINT file and config > > on a kernel config file says unknown ehci device. > > what tag are you checking your code out on? > > > > > > Any ideas? > > > > Thanks > > Michael E Mercer > > > > > > On Sat, 2004-03-27 at 18:53, Julian Elischer wrote: > > > >>Julian Elischer wrote: > >> > >>> I have the same Lexar Jumpdrive and it seems to work for me on an Asus > >>>P4PE > >>>with intel EHCI driver, as long as I plug it in AFTER booting. > >>> > >>>however: > >>>It hangs if I have the drive in during boot. > >>>It doesn't seem to give me the speed I get on another system > >>> > >>>BTW the speeds are: > >>> > >>>low speed (1.5Mb/Sec) > >>> > >>>full speed (12Mb/sec) > >>> > >>>high speed (480Mb/sec) > >>> > >>> > >>>I'm working on the USB code at the moment so I'm hoping to gete it fixed. > >> > >>I forgot to say that you need to configure the EHCI driver into our kernel > >>or you can not get USB2. > >>I notice it is not in your kernel dmesg.. > >> > >> > >>>-- original message: > >>> > >>>Hello, > >>> > >>> > >>>>I have an ASUS P4C-800-E Deluxe Motherboard, P4 3.0GHz processor with > >>>>builtin > >>>>USB 2.0 controllers. > >>>> > >>>>I am having a problem with the Lexar Media JumpDrive 2.0 Pro 256M > >>>>memory keystick. > >>>> > >>>>usbd nevers sees it. I finally went into BIOS and set the Speed for > >>>>the USB > >>>>2.0 Controller to FullSpeed (maybe HighSpeed, in whatever case its > >>>>12MBps as > >>>>opposed to 240MBps). When setting it to 12MBps, usbd sees the drive and > >>>>attaches it. Setting the speed to higher, usbd does NOT attach it. > >>>> > >>> > >>>I don't know how the Bios is connecte with this... > >>> > >>> > >>>>Also NOTE: I have a SIIG SlimHub 2.0 4 ports, that I can not attach my > >>>>JumpDrive too. I must set the speed to 12MBps and attach it directly to a > >>>>port on my PC to get it to see it. > >>>> > >>>>Any help in this would be appreciated. > >>>> > >>>>Thanks! Michael E. Mercer > >>>> > >>>>My system is the latest 4.9-Stable build as of yesterday. > >>> > >>> > >>>I committed some relevant stuff yesterday. make sure you have that.. > >>> > >> > > > > >
_______________________________________________ [EMAIL PROTECTED] mailing list http://lists.freebsd.org/mailman/listinfo/freebsd-stable To unsubscribe, send any mail to "[EMAIL PROTECTED]"
