On Fri, Dec 30, 2005 at 02:05:37PM +0000, Bill Smith wrote.. > The only little glitch in my 6.0-Stable system is this: > > atapci1: <Intel ICH5 SATA150 controller> port > 0xa800-0xa807,0xa400-0xa403,0xa000 > -0xa007,0x9800-0x9803,0x9400-0x940f irq 18 at device 31.2 on pci0 > atapci1: failed to enable memory mapping! > > I am not using this for booting off right now but will be at some time > in the future, is there something I can do to enable the memory mapping > for it, or should I just ignore it. > It is on an Asus P5P800.
P4P800 I guess? I have seen the same message on my P4P800 ever since I own it (I think). It ran 4-stable before. Works fine so I would not worry about it if I were you. -- Wilko Bulte [EMAIL PROTECTED] _______________________________________________ [email protected] mailing list http://lists.freebsd.org/mailman/listinfo/freebsd-stable To unsubscribe, send any mail to "[EMAIL PROTECTED]"
