Mark Kirkwood wrote:
I swapped out a TX2000 for a TX4000 today, and naively thought that I'd
just be able to plug in the new card and reboot. Unfortunately, it does
not detect the 4 drives (Maxtor 6E040L0).
Booting off the 6.0R install cd shows the card detected ok, and 6 ATA
channels - 2 on-board + 4 on-card. Running 'atacontrol list' from a
fixit shell lists the 4 channels with no drives attached.
Is there anything special that needed for the TX4000, compared to the
TX2000?
A slight update on this, I tried out a gentoo installation - it sees the
drives as scsi, whereas it saw the same ones as ata when attached to a
TX2000 - so I'm wondering if these newer TX4000's have had a firmware
change (as I *know* there are folks one this list that run the 4's....)
Cheers
Mark
_______________________________________________
[email protected] mailing list
http://lists.freebsd.org/mailman/listinfo/freebsd-stable
To unsubscribe, send any mail to "[EMAIL PROTECTED]"
