The following reply was made to PR usb/74989; it has been noted by GNATS. From: "Julien Gabel" <[EMAIL PROTECTED]> To: "John Baldwin" <[EMAIL PROTECTED]> Cc: [EMAIL PROTECTED], [EMAIL PROTECTED], [email protected] Subject: Re: usb/74989: (regression) Lost USB support between 5.2.1-RELEASE and 5.3-RELEASE on K7T266 Pro2. Date: Fri, 2 Dec 2005 23:37:06 +0100 (CET)
> Ok, yours is a more odd case. :) This is debatably a bug in your ASL, > but I think we can work around it. It is routing your USB interrupts > to IRQ 10 but is not using a link device to do it, and it is not > including an INTR_OVERRIDE entry in the MADT to change IRQ 10 from the > default of edge/trigger to level/low. The patch below forces all > hard-wired PCI interrupts routed via ACPI to be level/low. This patch > should apply both to HEAD and 6.x and maybe 5.x. > > Index: acpi_pcib.c > [...] Ok. I think you finally got it this time. Applied this patch against RELENG_6 and it seems to work fine now. I build and installed the kernel, set the loader.conf directives hint.acpi.0.disabled to 0 hint.apic.0.disabled to 0 and reboot on the system... it works well now, thank you ;) >> More precisely, here is a little tab... to be more accurate (i hope): >> >> --------------------------------------- >> USB support | ACPI | APIC | >> ------------------------ >> | on | off | on | off | >> --------------------------------------- >> Did not boot(*)| | XX | | XX | >> --------------------------------------- >> (*) The boot disk seems not be able to be used for the root mount, i.e. >> ufs:/dev/ad0s1a in my case. > If you could get a verbose dmesg for this case using a serial console I'd > be interested in looking at that too. Certainly! The output can be found at: http://www.thilelli.net/~jgabel/store/pub/PR/74989/serial.dmesg.boot-v Note: the kernel used for this boot was the just-previously-patched one. -- -jpeg. _______________________________________________ [email protected] mailing list http://lists.freebsd.org/mailman/listinfo/freebsd-usb To unsubscribe, send any mail to "[EMAIL PROTECTED]"
