Hans Petter Selasky wrote:
On Tuesday 22 September 2009 17:21:28 Pierre-Luc Drouin wrote:
Thanks!
It indicates that your device is not sending any data.
--HPS
So does it mean that the write statement (a status request) is not
transmitted to the device either?
No, the "xxx_get()" message means that the data you write is sent and
transmitted.
BTW: I have a FTDI adapter here, and it works fine with loopback when the
baudrate is set correctly.
Because this write statement should be
followed by data sent from the device and it effectively does on Linux.
And about SIGIO, shouldn't this signal be generated only when there is
data available to read? Why is it generated in asynchronous mode and
then the read statement returns EINTR?
Ed has to answer these questions. This stuff is not handled in the USB stack
for FTDI devices.
--HPS
In the manual page for the uftdi driver, the chip I am using (FT232BL)
is not listed. According to the FTDI website, it is based on FT8U232AM,
but it has extra functionalities. Have you had the chance to test an
device that uses either a FT232BM, FT232BL or FT232BQ chip? I just
tested the device on FreeBSD 7.2 and it does not work either...
Thanks
Pierre-Luc Drouin
_______________________________________________
[email protected] mailing list
http://lists.freebsd.org/mailman/listinfo/freebsd-usb
To unsubscribe, send any mail to "[email protected]"
