On Tuesday 11 December 2012 16:48:13 Mike Tancsa wrote:
> On 12/11/2012 6:49 AM, Hans Petter Selasky wrote:
> > On Tuesday 11 December 2012 12:34:11 Mike Tancsa wrote:
> >> hw.usb.timings.extra_power_up_time: 20
> >> hw.usb.timings.resume_recovery: 50
> >> hw.usb.timings.resume_wait: 50
> >> hw.usb.timings.resume_delay: 250
> >> hw.usb.timings.set_address_settle: 10
> >> hw.usb.timings.port_resume_delay: 40
> >> hw.usb.timings.port_powerup_delay: 300
> >> hw.usb.timings.port_reset_recovery: 250
> >> hw.usb.timings.port_root_reset_delay: 250
> >> hw.usb.timings.port_reset_delay: 50
> > 
> > Try to tune these up, one by one.
> 
> I doubled them all, and still only
> 
> 0(cage)# usbconfig
> ugen0.1: <EHCI root HUB Intel> at usbus0, cfg=0 md=HOST spd=HIGH
> (480Mbps) pwr=SAVE
> ugen1.1: <XHCI root HUB 0x1033> at usbus1, cfg=0 md=HOST spd=SUPER
> (5.0Gbps) pwr=SAVE
> ugen2.1: <EHCI root HUB Intel> at usbus2, cfg=0 md=HOST spd=HIGH
> (480Mbps) pwr=SAVE
> ugen1.2: <product 0x17ab vendor 0x0b05> at usbus1, cfg=0 md=HOST
> spd=HIGH (480Mbps) pwr=ON
> ugen1.3: <WinTV HVR-950 Hauppauge> at usbus1, cfg=0 md=HOST spd=HIGH
> (480Mbps) pwr=ON
> ugen2.2: <product 0x0024 vendor 0x8087> at usbus2, cfg=0 md=HOST
> spd=HIGH (480Mbps) pwr=SAVE
> ugen0.2: <product 0x0024 vendor 0x8087> at usbus0, cfg=0 md=HOST
> spd=HIGH (480Mbps) pwr=SAVE
> ugen0.3: <USB 3.0 SATA Bridge VIA Labs, Inc.> at usbus0, cfg=0 md=HOST
> spd=HIGH (480Mbps) pwr=ON
> ugen0.4: <product 0x1400 vendor 0x04d9> at usbus0, cfg=0 md=HOST spd=LOW
> (1.5Mbps) pwr=ON

Have you tried a 10-current kernel after r243780?

--HPS
_______________________________________________
freebsd-usb@freebsd.org mailing list
http://lists.freebsd.org/mailman/listinfo/freebsd-usb
To unsubscribe, send any mail to "freebsd-usb-unsubscr...@freebsd.org"

Reply via email to