On Wed, 22 Jan 2014 15:55:36 +0100 Hans Petter Selasky <h...@bitfrost.no>
wrote about Re: ATP USB flash failure (regression?):

HPS> > I'm not sure I understand what to do here. The old quirk setting
HPS> > that worked before was 0x0100. However, it looks like I cannot set
HPS> > these, anyway:

HPS> > root@mclane:~ # usbconfig -d 1.4 add_quirk NO_SYNCHRONIZE_CACHE
HPS> > Adding quirk 'NO_SYNCHRONIZE_CACHE' failed, continuing.

HPS> Correcting myself:
HPS> usbconfig -d X.Y add_quirk UQ_MSC_NO_SYNC_CACHE

I can add this just fine now. However, on reset it still fails:

---
root@mclane:~ # usbconfig -d 1.4 add_quirk UQ_MSC_NO_SYNC_CACHE
root@mclane:~ # usbconfig -d 1.4 reset

umass0: at uhub3, port 5, addr 4 (disconnected)
umass0: <ATP Electronics ATP IG eUSB SSD, class 0/0, rev 2.00/11.00, addr
4> on usbus1 umass0:  SCSI over Bulk-Only; quirks = 0x4101
umass0:8:0:-1: Attached to scbus8
(probe0:umass-sim0:0:0:0): INQUIRY. CDB: 12 00 00 00 24 00 
(probe0:umass-sim0:0:0:0): CAM status: CCB request completed with an error
(probe0:umass-sim0:0:0:0): Retrying command
(probe0:umass-sim0:0:0:0): INQUIRY. CDB: 12 00 00 00 24 00 
(probe0:umass-sim0:0:0:0): CAM status: CCB request completed with an error
(probe0:umass-sim0:0:0:0): Retrying command
(probe0:umass-sim0:0:0:0): INQUIRY. CDB: 12 00 00 00 24 00 
(probe0:umass-sim0:0:0:0): CAM status: CCB request completed with an error
(probe0:umass-sim0:0:0:0): Retrying command
(probe0:umass-sim0:0:0:0): INQUIRY. CDB: 12 00 00 00 24 00 
(probe0:umass-sim0:0:0:0): CAM status: CCB request completed with an error
(probe0:umass-sim0:0:0:0): Retrying command
(probe0:umass-sim0:0:0:0): INQUIRY. CDB: 12 00 00 00 24 00 
(probe0:umass-sim0:0:0:0): CAM status: CCB request completed with an error
(probe0:umass-sim0:0:0:0): Error 5, Retries exhausted
---


Still no device node showing up.


cu
  Gerrit
_______________________________________________
freebsd-usb@freebsd.org mailing list
http://lists.freebsd.org/mailman/listinfo/freebsd-usb
To unsubscribe, send any mail to "freebsd-usb-unsubscr...@freebsd.org"

Reply via email to