Hi Peter
I was able to successfully run through the steps and start running the
virtual machine. However, once I start the guest, the host freebsd machine
hangs.

I have installed the freebsd host in x86_64 machine.  This is the hw spec.
sysctl -a | egrep -i 'hw.machine|hw.model|hw.ncpu'
hw.machine: amd64
hw.model: Intel(R) Core(TM)2 Duo CPU     E7500  @ 2.93GHz
hw.ncpu: 2
hw.machine_arch: amd64

1. Is it that Bhyve is not fully running in 64 bit amd or x86 processor? Or
2. Is it that Byhve runs on 64 bit x86 but not 64 bit amd? If so, then I
will send the steps I followed along with the dump details.


Thanks

On Thu, Mar 29, 2012 at 4:13 PM, Peter Grehan <gre...@freebsd.org> wrote:

> Hi,
>
>
>  I was able to make progress. But I still have an issue.
>> In the step '9'
>> (http://people.freebsd.org/~**neel/bhyve/bhyve_instructions.**txt<http://people.freebsd.org/~neel/bhyve/bhyve_instructions.txt>),
>> I am
>> being asked to copy the guest file system. However I could not find any
>> file with the name 'filesystem' in the entire filesystem. Am I missing
>> any step here? Where is the right path to copy from?
>>
>
>  If you used the vm1.tar.gz in the instructions, you shouldn't have to do
> anything - the 'mdroot' file is already in there and in the right place.
>
> later,
>
> Peter.
>
_______________________________________________
freebsd-virtualization@freebsd.org mailing list
http://lists.freebsd.org/mailman/listinfo/freebsd-virtualization
To unsubscribe, send any mail to 
"freebsd-virtualization-unsubscr...@freebsd.org"

Reply via email to