On 12/27/13 8:49 PM, Neel Natu wrote:
> Hi John,
> 
> On Fri, Dec 27, 2013 at 9:05 AM, John Baldwin <j...@freebsd.org> wrote:
>> While hacking on the power button support, I also started rototilling the 
>> DSDT
>> generation code a bit.  My initial goal was to enumerate the LPC serial ports
>> (COM1 and COM2) properly via ACPI.  I ended up doing the following:
>>
>> - Moved the info for the top-level PCI bus into the PCI emulation code and
>>   added ResourceProducer entries for the memory ranges decoded by the bus
>>   for memory BARs.
>> - I added a framework to allow each PCI emulation driver to optionally write
>>   an entry into the DSDT under the \_SB_.PCI0 namespace.  The LPC driver uses
>>   this to write a node for the LPC bus (\_SB_.PCI0.ISA).
>> - I added a linker set to allow any LPC devices to write entries into the
>>   DSDT below the LPC node.  I moved the existing block for the RTC out of
>>   acpi.c and into the RTC driver.  I added DSDT nodes for the AT PIC,
>>   the 8254 ISA timer, and the LPC UART devices.
>> - I also added a "SuperIO" device under the LPC node to claim "system
>>   resources" (as is done in real hardware).  I added a linker set to allow
>>   various drivers to add IO or memory ranges that should be claimed by
>>   SuperIO and then added the extended RTC IO range and the registers used
>>   for ACPI power management as system resources.
>>
>> The end result is that for the stock VM created by vmrun.sh, the attimer0,
>> uart0, and uart1 devices move from isa0 to acpi0.  There is also a PIC
>> device that would be claimed by 'device atpic' (but the stock amd64 kernel
>> doesn't include that).  The DSDT is also a bit more fleshed out, and also
>> looks "nice" as devices are mostly laid out in the normal tree rather than
>> using separate Scope() sections for each device.
>>
>> Note that I did add some helper routines for writing out DSDT lines and
>> resource entries to try to simplify the code in the various DSDT handlers
>> and make the code that generates DSDT lines a bit more readable (e.g. the
>> implicit newlines make things more readable IMO).
>>
>> The patch is relative to the previous power button patch and is at
>> http://www.FreeBSD.org/~jhb/patches/bhyve_dsdt.patch
> 
> I am getting a "404 Not Found" at this URL.

Oops, I forgot to upload it to freefall.  It should be there now.

-- 
John Baldwin
_______________________________________________
freebsd-virtualization@freebsd.org mailing list
http://lists.freebsd.org/mailman/listinfo/freebsd-virtualization
To unsubscribe, send any mail to 
"freebsd-virtualization-unsubscr...@freebsd.org"

Reply via email to