With these in the config I see these messages:
Sep  9 18:39:45 cakebox kernel: ath0: stuck beacon; resetting (bmiss count 4)
Sep  9 18:42:57 cakebox kernel: ath0: stuck beacon; resetting (bmiss count 4)
Sep  9 18:45:49 cakebox kernel: ath0: stuck beacon; resetting (bmiss count 4)
Sep  9 18:46:28 cakebox kernel: ath0: stuck beacon; resetting (bmiss count 4)
Sep  9 18:46:31 cakebox kernel: ath0: stuck beacon; resetting (bmiss count 4)
Sep  9 18:46:49 cakebox kernel: ath0: stuck beacon; resetting (bmiss count 4)
Sep  9 18:46:52 cakebox kernel: ath0: stuck beacon; resetting (bmiss count 4)
Sep  9 18:47:02 cakebox kernel: ath0: stuck beacon; resetting (bmiss count 4)
Sep  9 18:49:43 cakebox kernel: ath0: stuck beacon; resetting (bmiss count 4)
Sep  9 18:52:00 cakebox kernel: ath0: stuck beacon; resetting (bmiss count 4)
Sep  9 19:03:29 cakebox kernel: ath0: stuck beacon; resetting (bmiss count 4)
Sep  9 19:04:51 cakebox kernel: ath0: ath_start: sc_inreset_cnt > 0; bailing

it also breaks pf and the kernel crashes with too much traffic.
So booted my previous kernel again.
Attached the athsurvey log until it crashed.
Alex.

Zitat von Adrian Chadd <adr...@freebsd.org>:

Hi, you need to add the ath debug and diagapi options.

Adrian
On Sep 8, 2012 3:29 PM, "Alexander Kühn" <alexander.ku...@nagilum.de> wrote:

athsurvey: ath0: Ung?ltiges Argument

..which translates to invalid argument.

$ ifconfig ath0
ath0: flags=8802<BROADCAST,SIMPLEX,**MULTICAST> metric 0 mtu 2290
        ether b0:48:7a:bc:cb:c3
        nd6 options=21<PERFORMNUD,AUTO_**LINKLOCAL>
        media: IEEE 802.11 Wireless Ethernet autoselect (autoselect
<hostap>)
        status: no carrier

Sorry.
Alex.

Zitat von Adrian Chadd <adr...@freebsd.org>:

 Hi,

COmpile/run athsurvey; paste the results here.

src/tools/tools/ath/athsurvey/



Adrian


On 8 September 2012 02:50, Alexander Kühn <alexander.ku...@nagilum.de>
wrote:

The following reply was made to PR kern/167491; it has been noted by
GNATS.

From: Alexander =?iso-8859-1?b?S/xobg==?= <alexander.ku...@nagilum.de>
To: bug-follo...@freebsd.org
Cc:
Subject: Re: kern/167491: [ath] TID != hardware queue TID in
 ath_tx_aggr_comp_aggr()
Date: Sat, 08 Sep 2012 11:42:47 +0200

 I see the same on x86 along with:

 messages.4.bz2:Sep  2 17:04:29 cakebox kernel: ath0: stuck beacon;
 resetting (bmiss count 4)
 messages.4.bz2:Sep  2 17:04:33 cakebox kernel: ath0: stuck beacon;
 resetting (bmiss count 4)
 messages.4.bz2:Sep  2 17:04:33 cakebox kernel: ath0: ath_start:
 sc_inreset_cnt > 0; bailing
 messages.4.bz2:Sep  2 17:05:12 cakebox kernel: ath0: ath_tx_tid_drain:
 node 0xc47ea000: bf=0xc350fcc0: addbaw=0, dobaw=0, seqno=0, retry=0
 messages.4.bz2:Sep  2 17:05:12 cakebox kernel: ath0: ath_tx_tid_drain:
 node 0xc47ea000: bf=0xc350fcc0: tid txq_depth=1 hwq_depth=0, bar_wait=0
 messages.4.bz2:Sep  2 17:05:12 cakebox kernel: ath0: ath_tx_tid_drain:
 node 0xc47ea000: tid 16: txq_depth=64, txq_aggr_depth=0, sched=0,
 paused=0, hwq_depth=0, incomp=0, baw_head=0, baw_tail=0 txa_start=-1,
 ni_txseqs=7
 messages.4.bz2:Sep  2 17:06:25 cakebox kernel: ath0: stuck beacon;
 resetting (bmiss count 4)

 Unfortunately this causes the transfer rates to drop and occasionally
 even makes it impossible to associate with the AP.

 dmesg:
 Copyright (c) 1992-2012 The FreeBSD Project.
 Copyright (c) 1979, 1980, 1983, 1986, 1988, 1989, 1991, 1992, 1993, 1994
          The Regents of the University of California. All rights
reserved.
 FreeBSD is a registered trademark of The FreeBSD Foundation.
 FreeBSD 10.0-CURRENT #0: Wed Aug 29 13:01:13 CEST 2012
      r...@cakebox.tis:/usr/obj/**export/src/sys/net5501 i386
 CPU: Geode(TM) Integrated Processor by AMD PCS (499.91-MHz 586-class
CPU)
    Origin = "AuthenticAMD"  Id = 0x5a2  Family = 5  Model = a  Stepping
= 2
    Features=0x88a93d<FPU,DE,PSE,**TSC,MSR,CX8,SEP,PGE,CMOV,**
CLFLUSH,MMX>
    AMD Features=0xc0400000<MMX+,**3DNow!+,3DNow!>
 real memory  = 536870912 (512 MB)
 avail memory = 515837952 (491 MB)
 K6-family MTRR support enabled (2 registers)
 cryptosoft0: <software crypto> on motherboard
 pcib0 pcibus 0 on motherboard
 pci0: <PCI bus> on pcib0
 Geode LX: Soekris net5501 comBIOS ver. 1.33 20070103 Copyright (C)
2000-2007
 glxsb0: <AMD Geode LX Security Block (AES-128-CBC, RNG)> mem
 0xa0000000-0xa0003fff irq 10 at device 1.2 on pci0
 vr0: <VIA VT6105M Rhine III 10/100BaseTX> port 0xe100-0xe1ff mem
 0xa0004000-0xa00040ff irq 11 at device 6.0 on pci0
 vr0: Quirks: 0x2
 vr0: Revision: 0x96
 miibus0: <MII bus> on vr0
 ukphy0: <Generic IEEE 802.3u media interface> PHY 1 on miibus0
 ukphy0:  none, 10baseT, 10baseT-FDX, 100baseTX, 100baseTX-FDX, auto,
auto-flow
 vr0: Ethernet address: 00:00:24:cb:a6:80
 vr1: <VIA VT6105M Rhine III 10/100BaseTX> port 0xe200-0xe2ff mem
 0xa0004100-0xa00041ff irq 5 at device 7.0 on pci0
 vr1: Quirks: 0x2
 vr1: Revision: 0x96
 miibus1: <MII bus> on vr1
 ukphy1: <Generic IEEE 802.3u media interface> PHY 1 on miibus1
 ukphy1:  none, 10baseT, 10baseT-FDX, 100baseTX, 100baseTX-FDX, auto,
auto-flow
 vr1: Ethernet address: 00:00:24:cb:a6:81
 vr2: <VIA VT6105M Rhine III 10/100BaseTX> port 0xe300-0xe3ff mem
 0xa0004200-0xa00042ff irq 9 at device 8.0 on pci0
 vr2: Quirks: 0x2
 vr2: Revision: 0x96
 miibus2: <MII bus> on vr2
 ukphy2: <Generic IEEE 802.3u media interface> PHY 1 on miibus2
 ukphy2:  none, 10baseT, 10baseT-FDX, 100baseTX, 100baseTX-FDX, auto,
auto-flow
 vr2: Ethernet address: 00:00:24:cb:a6:82
 vr3: <VIA VT6105M Rhine III 10/100BaseTX> port 0xe400-0xe4ff mem
 0xa0004300-0xa00043ff irq 12 at device 9.0 on pci0
 vr3: Quirks: 0x2
 vr3: Revision: 0x96
 miibus3: <MII bus> on vr3
 ukphy3: <Generic IEEE 802.3u media interface> PHY 1 on miibus3
 ukphy3:  none, 10baseT, 10baseT-FDX, 100baseTX, 100baseTX-FDX, auto,
auto-flow
 vr3: Ethernet address: 00:00:24:cb:a6:83
 ath0: <Atheros 5416> mem 0xa0010000-0xa001ffff irq 10 at device 14.0 on
pci0
 ath0: DMA setup: legacy
 ath0: [HT] enabling HT modes
 ath0: [HT] RTS aggregates limited to 8 KiB
 ath0: [HT] 2 RX streams; 2 TX streams
 ath0: AR5416 mac 13.10 RF2133 phy 8.1
 ath0: 2GHz radio: 0x0000; 5GHz radio: 0x00d0
 isab0: <PCI-ISA bridge> at device 20.0 on pci0
 isa0: <ISA bus> on isab0
 atapci0: <AMD CS5536 UDMA100 controller> port
 0x1f0-0x1f7,0x3f6,0x170-0x177,**0x376,0xe000-0xe00f at device 20.2 on
pci0
 ata0: <ATA channel> at channel 0 on atapci0
 ata1: <ATA channel> at channel 1 on atapci0
 ohci0: <OHCI (generic) USB controller> mem 0xa0020000-0xa0020fff irq
 15 at device 21.0 on pci0
 usbus0 on ohci0
 ehci0: <AMD CS5536 (Geode) USB 2.0 controller> mem
 0xa0021000-0xa0021fff irq 15 at device 21.1 on pci0
 usbus1: EHCI version 1.0
 usbus1 on ehci0
 cpu0 on motherboard
 orm0: <ISA Option ROM> at iomem 0xc8000-0xd27ff pnpid ORM0000 on isa0
 atrtc0: <AT realtime clock> at port 0x70 irq 8 on isa0
 Event timer "RTC" frequency 32768 Hz quality 0
 attimer0: <AT timer> at port 0x40 on isa0
 Timecounter "i8254" frequency 1193182 Hz quality 0
 Event timer "i8254" frequency 1193182 Hz quality 100
 uart0: <16550 or compatible> at port 0x3f8-0x3ff irq 4 flags 0x10 on
isa0
 uart0: console (19200,n,8,1)
 uart1: <16550 or compatible> at port 0x2f8-0x2ff irq 3 on isa0
 Timecounters tick every 1.000 msec
 usbus0: 12Mbps Full Speed USB v1.0
 usbus1: 480Mbps High Speed USB v2.0
 ugen0.1: <AMD> at usbus0
 uhub0: <AMD OHCI root HUB, class 9/0, rev 1.00/1.00, addr 1> on usbus0
 ugen1.1: <AMD> at usbus1
 uhub1: <AMD EHCI root HUB, class 9/0, rev 2.00/1.00, addr 1> on usbus1
 ad0: 152627MB <SAMSUNG HM160HC LQ100-10> at ata0-master UDMA100
 GEOM_SCHED: Initializing global data.
 GEOM_SCHED: Loading: mp = 0xc0a9aa20, g_sched_class = 0xc0a9aa20.
 Timecounter "TSC" frequency 499912531 Hz quality 800
 uhub0: 4 ports with 4 removable, self powered
 Root mount waiting for: usbus1
 uhub1: 4 ports with 4 removable, self powered
______________________________**_________________
freebsd-wireless@freebsd.org mailing list
http://lists.freebsd.org/**mailman/listinfo/freebsd-**wireless<http://lists.freebsd.org/mailman/listinfo/freebsd-wireless>
To unsubscribe, send any mail to "freebsd-wireless-unsubscribe@**
freebsd.org <freebsd-wireless-unsubscr...@freebsd.org>"




_______________________________________________
freebsd-wireless@freebsd.org mailing list
http://lists.freebsd.org/mailman/listinfo/freebsd-wireless
To unsubscribe, send any mail to "freebsd-wireless-unsubscr...@freebsd.org"

Reply via email to