That makes sense. I just added a couple of lines to rc.local for now. will update/test again in a month or so. The other option I thought might work would be to make 2 nodes from the ath0, wlan0 (station mode) and wlan1 (access point) and have the inside addresses on a separate network, might try that later.
Vince On 06/11/2013 23:22, Adrian Chadd wrote: > There's bugs with how interfaces are setup and wpa_supplicant is being > called. So I think this is just fallout from that. > > > :( > > > -adrian > > > On 6 November 2013 15:20, Vincent Hoffman <[email protected]> wrote: >> Hi, >> I'm trying to bring up a wlan interface with 2 IPs on it so I can >> NAT other devices on the wireless network. >> If I try and configure both IPs at boot via rc.conf I get no link and >> logs as follows >> Many repeating >> Nov 5 23:02:34 ostracod wpa_supplicant[676]: wlan0: Failed to initiate >> AP scan >> Nov 5 23:02:35 ostracod kernel: ath0: ath_legacy_rx_tasklet: >> sc_inreset_cnt > 0; skipping >> Nov 5 23:02:35 ostracod wpa_supplicant[676]: ioctl[SIOCS80211, op=103, >> val=0, arg_len=128]: Operation now in progress >> Nov 5 23:02:35 ostracod wpa_supplicant[676]: wlan0: Failed to initiate >> AP scan >> with the occasional >> Nov 5 23:04:51 ostracod kernel: ath0: ath_raw_xmit: sc_inreset_cnt > 0; >> bailing >> Nov 5 23:04:51 ostracod kernel: ath0: ath_raw_xmit: sc_inreset_cnt > 0; >> bailing >> >> in rc.conf I have: >> wlans_ath0="wlan0" >> ifconfig_wlan0="WPA inet 85.233.185.162/29 -bgscan" >> ifconfig_wlan0_alias0="inet 10.10.10.1/24" >> >> >> If however I add just one address and then create the alias manually >> later It works fine. >> >> ath device details >> >> ath0: <Atheros 5424/2424> mem 0xfebf0000-0xfebfffff irq 16 at device 0.0 >> on pci4 >> ath0: AR2425 mac 14.2 RF5424 phy 7.0 >> ath0: 2GHz radio: 0x0000; 5GHz radio: 0x00a2 >> >> ath0@pci0:4:0:0: class=0x020000 card=0x7131144f chip=0x001c168c >> rev=0x01 hdr=0x00 >> vendor = 'Atheros Communications Inc.' >> device = 'AR242x / AR542x Wireless Network Adapter (PCI-Express)' >> class = network >> subclass = ethernet >> >> OS details: >> FreeBSD ostracod.unsane.co.uk 10.0-BETA2 FreeBSD 10.0-BETA2 #71 r257498: >> Fri Nov 1 17:31:01 GMT 2013 >> [email protected]:/scratch/obj/usr/src/sys/OSTRACOD amd64 >> >> It seems unlikely this is expected and i'm not even sure its ath based >> but I dont have any other wireless interfaces to test with. >> Any suggestions? >> The system is in use at the moment but I can test from time to time. >> >> Vince >> >> >> _______________________________________________ >> [email protected] mailing list >> http://lists.freebsd.org/mailman/listinfo/freebsd-wireless >> To unsubscribe, send any mail to "[email protected]" _______________________________________________ [email protected] mailing list http://lists.freebsd.org/mailman/listinfo/freebsd-wireless To unsubscribe, send any mail to "[email protected]"
