Hah, looks like the exact same layout as the atheros reference design DB120.
On 2 January 2015 at 15:11, Mike <[email protected]> wrote: > Hello! > This is device which probably supported by FreeBSD/MIPS + Atheros drivers. > Serial console pinout on 4pin connector is: > Vcc/GND/RX/TX > To get uboot prompt while router boots you should type "tpl" and press > enter quickly while uboot outputs "Autobooting in 1 seconds". > Here is uboot env: > U-Boot 1.1.4 (Jun 17 2013 - 12:31:57) > > U-boot DB120 > > > DRAM: 128 MB > id read 0x100000ff > flash size 8MB, sector count = 128 > Flash: 8 MB > Using default environment > > PCIe Reset OK!!!!!! > In: serial > Out: serial > Err: serial > Net: ag934x_enet_initialize... > No valid address in Flash. Using fixed address > wasp reset mask:c03300 > WASP ----> S17 PHY * > : cfg1 0x7 cfg2 0x7114 > eth0: ba:be:fa:ce:08:41 > athrs17_reg_init: complete > eth0 up > eth0 > Autobooting in 1 seconds > db12x> > db12x> printenv > bootargs=console=ttyS0,115200 root=31:02 rootfstype=squashfs > init=/sbin/init > mtdparts=ath-nor0:256k(u-boot),64k(u-boot-env),6336k(rootfs),1408k(uImage),64k(mib0),64k(ART) > bootcmd=bootm 0x9f020000 > bootdelay=1 > baudrate=115200 > ethaddr=0xba:0xbe:0xfa:0xce:0x08:0x41 > ipaddr=192.168.1.111 > serverip=192.168.1.100 > dir= > lu=tftp 0x80060000 ${dir}u-boot.bin&&erase 0x9f000000 +$filesize;cp.b > $fileaddr 0x9f000000 $filesize > lf=tftp 0x80060000 ${dir}db12x${bc}-jffs2&&erase 0x9f050000 > +0x630000;cp.b $fileaddr 0x9f050000 $filesize > lk=tftp 0x80060000 ${dir}vmlinux${bc}.lzma.uImage&&erase 0x9f680000 > +$filesize;cp.b $fileaddr 0x9f680000 $filesize > stdin=serial > stdout=serial > stderr=serial > ethact=eth0 > > Environment size: 686/65532 bytes > db12x> > > -- > With best regards from Russia, Mike _______________________________________________ [email protected] mailing list http://lists.freebsd.org/mailman/listinfo/freebsd-wireless To unsubscribe, send any mail to "[email protected]"
