Hello community,
Im using a Wifi AP with an Atheros card now for quite some time, since a
couple of FreeBSD revisions. I guess started back on FreeBSD 10(?).
My wifi AP seem to limit me to 2MB/s basically, which is pretty slow.
Im not sure if all my options are ok, or if there are some ways I can
tweak around it...
Is this a limitation of the current driver?
Would be very interesting to hear from someone who runs a similar setup
and has more speed/throughput than I do.
I only have this box with this card, cant really tinker a lot around
with other cards - and as I know Atheros is one of the drivers which is
better supported than others.
Back then it was quite hard to get 5GHz running correctly....
Some of my debug output, config files etc.:
-------------------------------dmesg-ath-------------------------------
ath0: <Atheros 9280> mem 0xfe800000-0xfe80ffff at device 0.0 on pci4
[ath] enabling AN_TOP2_FIXUP
ath0: [HT] enabling HT modes
ath0: [HT] 1 stream STBC receive enabled
ath0: [HT] 1 stream STBC transmit enabled
ath0: [HT] 2 RX streams; 2 TX streams
ath0: AR9280 mac 128.2 RF5133 phy 13.0
ath0: 2GHz radio: 0x0000; 5GHz radio: 0x00c0
-------------------------------dmesg-ath-------------------------------
-------------------------ifconfig-wlan0--------------------------------
wlan0: flags=8943<UP,BROADCAST,RUNNING,PROMISC,SIMPLEX,MULTICAST> metric
0 mtu 1500
ether XX:XX:XX:XX:XX:XX
hwaddr XX:XX:XX:XX:XX:XX
nd6 options=29<PERFORMNUD,IFDISABLED,AUTO_LINKLOCAL>
media: IEEE 802.11 Wireless Ethernet autoselect mode 11na <hostap>
status: running
ssid XXXXXXXXXXX channel 40 (5200 MHz 11a ht/20) bssid XX:XX:XX:XX:XX:XX
regdomain ETSI country DE ecm authmode WPA2/802.11i privacy MIXED
deftxkey 2 AES-CCM 2:128-bit AES-CCM 3:128-bit txpower 17 mcastrate 6
mgmtrate 6 scanvalid 60 ampdulimit 64k ampdudensity 8 shortgi wme
burst dtimperiod 1 -dfs
groups: wlan
-------------------------ifconfig-wlan0--------------------------------
As you can see Im using "country DE" - but this cant be the reason for
such slow speed?
-------------------------rc.conf--------------------------------------
create_args_wlan0="wlanmode hostap channel 40:ht/20 country de"
-------------------------rc.conf--------------------------------------
------------------------hostapd.conf----------------------------------
interface=wlan0
ctrl_interface=/var/run/hostapd
ctrl_interface_group=0
ssid=XXXXXXXXXXXXXXXXXXXXXx
wmm_enabled=1
ieee80211d=1
country_code=DE
wpa=2
wpa_passphrase=XXXXXXXXXXXXXXXX
wpa_key_mgmt=WPA-PSK
wpa_pairwise=CCMP
rsn_pairwise=CCMP
------------------------hostapd.conf----------------------------------
best regards,
--
Georg Bege
Mail: [email protected]
IRC: megaTherion @ Freenode
_______________________________________________
[email protected] mailing list
https://lists.freebsd.org/mailman/listinfo/freebsd-wireless
To unsubscribe, send any mail to "[email protected]"
