On Tue, Apr 22, 2014 at 12:16:34PM +1000, Robert Backhaus wrote: > > Thanks. First thing to do is rebuild and reinstall print/cups-client . That > port installs the file that includes the typedef that it is complaining > about. My programming skills are very low, especially when it comes to the > tangle of typedefs. You may have to wait for someone else to help you. > > > On 22 April 2014 11:09, Cary <[email protected]> wrote: > > > On Tue, Apr 22, 2014 at 10:30:37AM +1000, Robert Backhaus wrote: > > > On 22 April 2014 09:41, Cary <[email protected]> wrote: > > > > > > > print/xfce4-print builds normally on 9.2-R with default config, > > > > but build fails when port is configured with "--enable-cups" rather > > > > than "--enable-bsdlpr". > > > > > > > > STDERR attached. > > > > > > > > > > Could we have a little more information? The command lines for that error > > > would be good. Editing the makefile to add MAKE_JOBS_UNSAFE=yes would > > make > > > them easier to read too. > > > > Hi Robert, > > > > Here is output from running make again with MAKE_JOBS_UNSAFE set > > to "YES" in /etc/make.conf . > > > > thanks, > > Cary > > --
Robert, Thank you for your help. After rebuilding print/cups-client-1.7.1 I tried again to build the print/xfce4-print port. It stopped in the same place. The port installed is built with the default configuration. In any case, cups will print without support from xfce4-print. Cary -- [email protected] SDF Public Access UNIX System - http://sdf.org _______________________________________________ [email protected] mailing list http://lists.freebsd.org/mailman/listinfo/freebsd-xfce To unsubscribe, send any mail to "[email protected]"
