Hi, All. Обновился с FreeBSD9.3 до 10.2 После этого сервак стал виснуть. В логах - ничего подозрительного. Единственная зацепка в консоли:
aacraid0: COMMAND 0xffffffe00000a7d318 TIMEOUT AFTER 744 SECONDS aacraid0: shutting down controller... FAILED aacraid0: IOP_RESET failed ... и так много-много раз. До этого все работало все стабильно на драйвере с сайта производителя. После апдейта пробовал оставить системный драйвер (v 3.2-5) и последний драйвер с сайта, правда для 10.1 (3.2-9 (41018)). Результат тот же. Спустя некоторое время сервак жестко виснет. Помогает только кнопка ресет. Информация о системе: #uname -a FreeBSD hosname 10.2-RELEASE-p16 FreeBSD 10.2-RELEASE-p16 #0 r299215: Sat May 7 22:39:00 EEST 2016 root@hostname:/usr/obj/usr/src/sys/GENERIC amd64 #arcconf GETCONFIG 1 AD Controllers found: 1 ---------------------------------------------------------------------- Controller information ---------------------------------------------------------------------- Controller Status : Optimal Channel description : SAS/SATA Controller Model : Adaptec 6405E Controller Serial Number : 2A0611E6D40 Controller World Wide Name : 50000D1105064180 Controller Alarm : Enabled Physical Slot : 8 Temperature : 63 C/ 145 F (Normal) Installed memory : 128 MB Global task priority : High Performance Mode : Default/Dynamic Host bus type : PCIe Host bus speed : 5000 MHz Host bus link width : 1 bit(s)/link(s) Stayawake period : Disabled Spinup limit internal drives : 0 Spinup limit external drives : 0 Defunct disk drive count : 0 Logical devices/Failed/Degraded : 1/0/0 NCQ status : Enabled Statistics data collection mode : Enabled -------------------------------------------------------- RAID Properties -------------------------------------------------------- Copyback : Disabled Background consistency check : Disabled Background consistency check period : 30 Automatic Failover : Enabled -------------------------------------------------------- Controller Version Information -------------------------------------------------------- BIOS : 5.2-0 (18668) Firmware : 5.2-0 (18668) Driver : 3.2-9 (41018) Boot Flash : 5.2-0 (18668) #gpart show => 34 3900682173 da0 GPT (1.8T) 34 128 1 freebsd-boot (64K) 162 3871342464 2 freebsd-ufs (1.8T) 3871342626 29339580 3 freebsd-swap (14G) 3900682206 1 - free - (512B) #dmesq -a aacraidu0: <Adaptec RAID Controller> mem 0xf7400000-0xf77fffff,0xf7841000-0xf78417ff,0xf7840000-0xf78400ff irq 18 at device 0.0 on pci3 aacraidu0: Enable Raw I/O aacraidu0: Enable 64-bit array aacraidu0: using MSI interrupts aacraidu0: New comm. interface type1 enabled aacraidu0: Adaptec 6405E, aacraid driver 3.2.9-41018 aacraidp0 on aacraidu0 aacraidp1 on aacraidu0 aacraidp2 on aacraidu0 aacraidp3 on aacraidu0 ... Starting file system checks: /dev/da0p2: INCORRECT BLOCK COUNT I=51148856 (8 should be 0) (CORRECTED) /dev/da0p2: UNREF FILE I=20838408 OWNER=root MODE=100666 /dev/da0p2: SIZE=0 MTIME=May 18 08:52 2016 (CLEARED) /dev/da0p2: UNREF FILE I=20838409 OWNER=mysql MODE=100600 /dev/da0p2: SIZE=0 MTIME=May 18 08:52 2016 (CLEARED) /dev/da0p2: UNREF FILE I=20838439 OWNER=mysql MODE=100600 /dev/da0p2: SIZE=0 MTIME=May 18 08:52 2016 (CLEARED) /dev/da0p2: UNREF FILE I=20838440 OWNER=mysql MODE=100600 /dev/da0p2: SIZE=0 MTIME=May 18 08:52 2016 (CLEARED) /dev/da0p2: UNREF FILE I=20838451 OWNER=mysql MODE=100600 /dev/da0p2: SIZE=0 MTIME=May 18 08:52 2016 (CLEARED) /dev/da0p2: UNREF FILE I=20838454 OWNER=mysql MODE=100600 /dev/da0p2: SIZE=0 MTIME=May 18 08:52 2016 (CLEARED) /dev/da0p2: UNREF FILE I=20838461 OWNER=root MODE=100644 /dev/da0p2: SIZE=0 MTIME=May 18 15:16 2016 (CLEARED) /dev/da0p2: UNREF FILE I=20838462 OWNER=root MODE=100644 /dev/da0p2: SIZE=0 MTIME=May 18 15:16 2016 (CLEARED) /dev/da0p2: UNREF FILE I=51148856 OWNER=root MODE=100644 /dev/da0p2: SIZE=0 MTIME=May 18 15:16 2016 (CLEARED) /dev/da0p2: LINK COUNT FILE I=51148864 OWNER=root MODE=100644 /dev/da0p2: SIZE=0 MTIME=May 18 15:16 2016 COUNT 2 SHOULD BE 1 (ADJUSTED) /dev/da0p2: UNREF FILE I=64693823 OWNER=root MODE=140666 /dev/da0p2: SIZE=0 MTIME=May 18 08:52 2016 (CLEARED) /dev/da0p2: FREE BLK COUNT(S) WRONG IN SUPERBLK (SALVAGED) /dev/da0p2: SUMMARY INFORMATION BAD (SALVAGED) /dev/da0p2: BLK(S) MISSING IN BIT MAPS (SALVAGED) /dev/da0p2: 5016764 files, 227589241 used, 248724853 free (175381 frags, 31068684 blocks, 0.0% fragmentation) Mounting local file systems:. После этого - нормальная загрузка. С драйвером из системы 3.2-5 - ситуация не меняется. -- Best regards, Aleksandr Khomenko
