Do you have any other "Non-freedos VM" that is working ok with "bridged mode"?
________________________________ From: Ben Barker <[email protected]> Sent: Monday, February 10, 2020 04:27 PM To: Discussion and general questions about FreeDOS. <[email protected]> Subject: Re: [Freedos-user] Bridged virtualbox adapter I haven't been usind DNS for now - just IP addresses On the machine that is working, I have set up Trumpet TCP and can ping out to the network, or in from the network On the other (using the same ova file on new hardware) I can ping 127.0.0.1, but any other destination returns "cannot resolve hosts hardware address" On both machines, when freeDos starts, I see: Packet Driver is at segment 03EE Interrupt number 0x9 (9) I/O port 0xD000 (53248) My ethernet address is <a mac address> That last line suggests that the MAC local MAC address is known.... Running wireshark on the virtualbox host machine shows no evidence that traffic is leaving the VM at all On Mon, Feb 10, 2020 at 9:14 PM Jose Isaias Cabrera <[email protected]<mailto:[email protected]>> wrote: Ben Barker, on Monday, February 10, 2020 03:57 PM, wrote... > > Cheers - yes I checked that. I think perhaps it is some oddity of the > host machine. On a different host (same subnet, same settings, but > different NIC hardware) it seems to work as expected Can you ping the name and the IP address from both places? Does nslookup for both machine and full DNS address return the same IP address? > But I have tried a few virtual adapters on this machine and when in > bridged mode all tell me "cannot resolve hosts hardware address" > > I have tried using Trumped and mTCP - so perhaps the issue is with the > packet driver / virtual adapter... > > On Mon, Feb 10, 2020 at 7:37 PM Louis Santillan > <[email protected]<mailto:[email protected]>> > wrote: > > Are your `IPADDR`, `NETMASK` & `GATEWAY` vars that which match the > subnet of the Ubuntu machine? `IPADDR` & the `ethernet address` > should be unique from your Ubuntu machine's setting. > > To compare, in Ubuntu, type `ip a` or `ifconfig`. > > On Mon, Feb 10, 2020 at 5:18 AM Alain Mouette > <[email protected]<mailto:[email protected]>> wrote: > > > > Use netbootdisk.com<http://netbootdisk.com> to setup your NIC > > > > > > Em 10/02/2020 09:02, Ben Barker escreveu: > > > > Morning > > I have a freedos install running on virtualBox, with the host machine > being Ubuntu > > > > If I run the networking in NAT mode, all is fine > > > > If I try "bridged mode", then at startup fDos sees the network adapter, > and reports: > > > > Interrupt number 0x9 (9) > > I/O port -xD020 (53280) > > My ethernet address is xxxxxxxx > > > > but any attempt to see the outside network gives the error: > > > > "cannot resolve host's hardware address" > > > > My mtcp.cfg is: > > > > PACKETINT 0x09 (tried a few values here...) > > IPADDR xxxxx > > NETMASK xxxxx > > GATEWAY xxxxx > > NAMESERVER xxxxx > > > > Any ideas...? > > _______________________________________________ Freedos-user mailing list [email protected]<mailto:[email protected]> https://lists.sourceforge.net/lists/listinfo/freedos-user
_______________________________________________ Freedos-user mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/freedos-user
