On 29.01.2016 09:01, Martin Babinsky wrote:
On 01/20/2016 09:40 AM, Martin Babinsky wrote:
On 01/14/2016 05:29 PM, Martin Babinsky wrote:
On 01/13/2016 05:59 PM, Rob Crittenden wrote:
Martin Babinsky wrote:
fixes https://fedorahosted.org/freeipa/ticket/5584

In order to ensure consistent behavior with ipa-client-install, I opted
to reuse the configure_openldap_conf() function and restoring the
config
from client sysrestore before modifying it.

If you think this approach is not optimal please propose an alternative
solution.

You could also just do an action set on URI to change the value, right?
It would need a new function but it would be very small.

If you do end up keeping this I'd want a new commit message for moving
the code to include why you're moving it (to avoid the need to deference
the ticket).

rob


Here's the patch that implements the change in URI directive. Please
keep in mind that we not only have to change the URI to point to
ourselves, we also have to do it in a way consistent with
ipa-client-install, i.e. leave a comment with new URI if it was already
set by third party.

Plain 'addifnotset' directive will not do, however, because then we end
up with two comments, one original, and one pointing to ourselves. Plain 'set' may rewrite the URI set by user and thus we would have to test its
value anyway.

The correct handling of these cases coupled with a way IPAChangeConf is
written results in a solution presented here.

The fact that it is not much shorter than configure_openldap_conf and is
additionally pretty ugly (a fact at least partially caused by me not
being very fluent in IPAChangeConf usage) led me to the conclusion that
restoring original ldap.conf and reusing already wirrten code for
reediting it anew with replica as URI is actually not that bad idea.




Bump for review/discussion.

Another bump.

Works for me, ACK

--
Manage your subscription for the Freeipa-devel mailing list:
https://www.redhat.com/mailman/listinfo/freeipa-devel
Contribute to FreeIPA: http://www.freeipa.org/page/Contribute/Code

Reply via email to