Hi Werner, Kurt, The support should be there in this branch.
svn co http://svn.savannah.gnu.org/svn/freeipmi/branches/ibmx3850x5 can you please check it out and LMK if it works for you. ./autogen.sh; ./configure ; ipmi-sensors/ipmi-sensors --output-sensor-state Should be enough to test it out on the node (or add appropriate options to run out of band). Al On Fri, 2012-06-15 at 10:28 -0700, Albert Chu wrote: > Hi Werner, Kurt, > > Yup, there are a lot of new permutations on this motherboard I haven't > seen before. I'll get them added into FreeIPMI for the next release. > > Al > > On Fri, 2012-06-15 at 02:39 -0700, Werner Fischer wrote: > > Hi Al, > > > > Kurt - a user of the IPMI plugin for Nagios/Icinga - reported on our > > mailing list that an supposed critical event ('transition to Critical > > from less severe') does not cause a warning through our plugin. > > > > Reason is that the reported sensor state is "N/A" so I think that > > FreeIPMI cannot interpret it's state: > > ID | Name | Type | State | Reading | Units | Event > > 387 | Ext QPI Link 2 | Slot/Connector | N/A | N/A | N/A | > > 'transition to Critical from less severe' > > > > There are also some other sensors, which report events, but are not > > recognized by FreeIPMI widely enough so FreeIPMI could give a State > > information (state is N/A): > > 22 | Scale Config | Version Change | N/A | > > N/A | N/A | 'OK' > > [...] > > 66 | VT Fault | Chassis | N/A | > > N/A | N/A | 'OK' > > [...] > > 386 | Ext QPI Link 1 | Slot/Connector | N/A | > > N/A | N/A | 'OK' > > 387 | Ext QPI Link 2 | Slot/Connector | N/A | > > N/A | N/A | 'transition to Critical from less severe' > > 388 | Ext QPI Link 3 | Slot/Connector | N/A | > > N/A | N/A | 'OK' > > 389 | Ext QPI Link 4 | Slot/Connector | N/A | > > N/A | N/A | 'OK' > > 390 | CPU 1 Int Link | Cable/Interconnect | N/A | > > N/A | N/A | 'OK' > > 391 | CPU 2 Int Link | Cable/Interconnect | N/A | > > N/A | N/A | 'OK' > > 392 | CPU 3 Int Link | Cable/Interconnect | N/A | > > N/A | N/A | 'OK' > > 393 | CPU 4 Int Link | Cable/Interconnect | N/A | > > N/A | N/A | 'OK' > > 394 | Scaling Failed | Boot Error | N/A | > > N/A | N/A | 'OK' > > 395 | Lane Failover 1 | Memory | N/A | > > N/A | N/A | 'OK' > > 396 | MemSpareErr1 | Memory | N/A | > > N/A | N/A | 'OK' > > 397 | MemSpareErr2 | Memory | N/A | > > N/A | N/A | 'OK' > > 398 | MemSpareErr3 | Memory | N/A | > > N/A | N/A | 'OK' > > 399 | MemSpareErr4 | Memory | N/A | > > N/A | N/A | 'OK' > > 400 | MemSpareErr5 | Memory | N/A | > > N/A | N/A | 'OK' > > 401 | MemSpareErr6 | Memory | N/A | > > N/A | N/A | 'OK' > > 402 | MemSpareErr7 | Memory | N/A | > > N/A | N/A | 'OK' > > 403 | MemSpareErr8 | Memory | N/A | > > N/A | N/A | 'OK' > > 404 | Lane Failover 2 | Memory | N/A | > > N/A | N/A | 'OK' > > 405 | Lane Failover 3 | Memory | N/A | > > N/A | N/A | 'OK' > > 406 | Lane Failover 4 | Memory | N/A | > > N/A | N/A | 'OK' > > 407 | Lane Failover 5 | Memory | N/A | > > N/A | N/A | 'OK' > > 408 | Lane Failover 6 | Memory | N/A | > > N/A | N/A | 'OK' > > 409 | Lane Failover 7 | Memory | N/A | > > N/A | N/A | 'OK' > > 410 | Lane Failover 8 | Memory | N/A | > > N/A | N/A | 'OK' > > [...] > > 426 | FPGA FW Mismatch | Version Change | N/A | > > N/A | N/A | 'OK' > > 427 | TPM Phys Pres | Button/Switch | N/A | > > N/A | N/A | 'OK' > > [...] > > 429 | No I/O Resources | System Firmware Progress | N/A | > > N/A | N/A | 'OK' > > 430 | Memory Resize | POST Memory Resize | N/A | > > N/A | N/A | 'OK' > > [...] > > 433 | IMM FW Failover | Version Change | N/A | > > N/A | N/A | 'OK' > > > > Are there chances that you could add support for those sensors to future > > FreeIPMI versions? > > > > You can get verbose output in the following posting (scroll down to the > > end) > > http://lists.thomas-krenn.com/pipermail/ipmi-plugin-user/2012-June/000182.html > > > > I have put Kurt on CC and asked him to subscribe to > > [email protected] so he can get in touch with you directly, too. > > > > Best regards, > > Werner > > -- Albert Chu [email protected] Computer Scientist High Performance Systems Division Lawrence Livermore National Laboratory _______________________________________________ Freeipmi-devel mailing list [email protected] https://lists.gnu.org/mailman/listinfo/freeipmi-devel
