I am using the same pool configuration. This arrangemnt suits to our requirement but only one problem that we cannot stop it assigning the IP beyond our limit of subnet. Our last IP in the range is x.x.x.254 but when this too is assigned the next dial-in user get IP which is not in our subnet.
Is there any wayout. May be manual? I mean something like reset so that radius start assigning IP from beginning of the range of IP address.
Sent: Thursday, December 27, 2001 3:07 AM
To: [EMAIL PROTECTED]
Subject: Re: IP Pools.
"Michael Anderson" <[EMAIL PROTECTED]> wrote:
> I have been looking for a couple hours now, and can't see where I can set up
> IP Pools.
That's because there is no support for IP pools.
You can use 'Framed-IP-Address = 1.2.3.4+' to fake out pools,
though.
Alan DeKok.
-
List info/subscribe/unsubscribe? See http://www.freeradius.org/list/users.html
--------------------------------------------------------------------
If you are not the addressee indicated in this electronic mail or
responsible for delivering this electronic message to the intended
recipient, you should delete this message and notify the sender
immediately.
--------------------------------------------------------------------
Disclaimer:
Any non official business related views, opinions or other information presented in this electronic mail are solely those of the sender/author. Burgan Bank does not endorse or accept responsibility for these opinions, views or conclusion.
If you are not the addressee indicated in this electronic mail or responsible for delivering this electronic message to the intended recipient, you should delete this message and notify the sender immediately.
Burgan Bank
