I did that. total debugging on radius and looking at the logs, and even debug on the cisco. far as I can tell the cisco never sees this. doesnt show up in the debugs or logs anywhere...
tried += as well, and := and == just to see, none of that worked. I'm wondering if it needs a special IOS version like a "T" version. We use 12.2(6) right now. plain ip plus sec56, not the service provider version or anything. any suggestions ? Dan. On Thu, 14 Nov 2002, Kevin Bonner wrote: > On Wednesday 13 November 2002 14:31, Dan wrote: > > testuser Auth-Type := System > > Framed-Ip-Address = .... > > Cisco-AVPair = "lcp:interface-config=rate-limit output 128000 32000 >64000 > > conform-action transmit exceed-action drop" > > This is basically what we use to set limits on some customers. Enable as much > radius debugging on the cisco as possible and look at the cisco logs to see > what it is doing with this setting. > > Kevin Bonner > > - > List info/subscribe/unsubscribe? See http://www.freeradius.org/list/users.html > - List info/subscribe/unsubscribe? See http://www.freeradius.org/list/users.html
