Hi Freesurfer experts,

I found the answer to my previous question on FreeSurfer Wiki regarding 
pre-smoothing command line for LGI ( I am interested in looking at 
between-group differences in vertwex-wise LGI values).

I am now aware that the following command line must be used:

recon-all -s <subjid> -qcache -measure pial_lgi

However, if I also want to look at surface area differences between groups 
later on, is using the above pre-smoothing command line correct? OR do I have 
to use the following command line considering that I Am not only looking at LGI 
values : recon-all -s <subjid> -qcache

Would really appreciate your advice,



CONFIDENTIALITY NOTICE: This e-mail message, including any attachments, is for 
the sole use of the intended recipient(s) and may contain confidential and 
privileged information. Any unauthorized review, use, disclosure or 
distribution is prohibited. If you are not the intended recipient, please 
contact the sender by reply e-mail and destroy all copies of the original 

AVIS DE CONFIDENTIALITÉ : Ce message électronique, ainsi que tout fichier qui y 
est joint, est reserve à l'usage exclusif du destinataire visé et peut contenir 
des renseignements confidentiels et privilégiés. Toute lecture, utilisation, 
divulgation ou distribution non autorisée est interdite. Si vous n'êtes pas le 
destinataire visé, veuillez en aviser l'expéditeur par retour de courriel et 
détruire toutes les copies du message original.
Freesurfer mailing list

The information in this e-mail is intended only for the person to whom it is
addressed. If you believe this e-mail was sent to you in error and the e-mail
contains patient information, please contact the Partners Compliance HelpLine at
http://www.partners.org/complianceline . If the e-mail was sent to you in error
but does not contain patient information, please contact the sender and properly
dispose of the e-mail.

Reply via email to