Hi Klaus,
You might want to try setting the variables before originating the call
- the 'originate' will cause the call setup message to be sent.
--Dave
OK, Let me give you the full picture; here is what i do, but it still doesn't
work. baiscally, i just want to dial two users and connect them to each other.
Each side seeing the number of the other side as caller id.
new_session2 = new Session();
new_session2.originate(null, 'sofia/gateway/sip.gafachi.com/1'+caller_number,
15);
new_session2.setVariable("origination_caller_id_number", callee_number);
new_session2.setVariable("origination_caller_id_name", 'Klaus Teller');
new_session2.waitForAnswer(10000);
new_session1 = new Session();
new_session1.originate(new_session2,
'sofia/gateway/sip.gafachi.com/1'+callee_number, 15);
new_session1.setVariable("effctive_caller_id_number", caller_number);
new_session1.setVariable("effective_caller_id_name", 'Klaus Teller');
I also tried effective on both sides as well as origibation on both sides.
Klaus.
-------- Original-Nachricht --------
Datum: Tue, 29 Jul 2008 23:36:10 -0500
Von: Brian West <[EMAIL PROTECTED]>
An: [email protected]
Betreff: Re: [Freeswitch-users] Gafachi Again
This is clearly a case where you're creating an A leg. Let me lay out
some info here that will clear this up...
origination_caller_id_name / origination_caller_id_number - These to
variables are used to set the caller_id info on a leg that you are
creating in this case the A-Leg
While the effective_caller_id_name / effective_caller_id_number are
used to set the caller id for any legs that are born from the A-leg,
these values are used on the B-leg's caller_id_name/number values.
/b
On Jul 29, 2008, at 11:21 PM, Klaus Teller wrote:
I just did the following:
new_session1 = new Session();
new_session1.originate(new_session2, 'sofia/gateway/sip.gafachi.com/
1'+callee_number, 15);
new_session1.setVariable("effective_caller_id_number", caller_number);
new_session1.setVariable("effective_caller_id_name", 'Klaus Teller');
As a result, I have the callee number being shown on its own display
as caller. That is on the called device the number callee_number is
being displayed instead of caller_number.
What am i doing wrong?
Klaus.
Brian West
sip:[EMAIL PROTECTED]
_______________________________________________
Freeswitch-users mailing list
[email protected]
http://lists.freeswitch.org/mailman/listinfo/freeswitch-users
UNSUBSCRIBE:http://lists.freeswitch.org/mailman/options/freeswitch-users
http://www.freeswitch.org
--
David Knell, Director, 3C Limited
T: 020 8114 8901 F: 020 3002 7257 M: 001 415 630 3031
http://www.3c.co.uk
_______________________________________________
Freeswitch-users mailing list
[email protected]
http://lists.freeswitch.org/mailman/listinfo/freeswitch-users
UNSUBSCRIBE:http://lists.freeswitch.org/mailman/options/freeswitch-users
http://www.freeswitch.org
