Actually Brain mentioned that you can comment out switch_nat_init();
in switch_core.c
On Jun 2, 2009, at 7:08 PM, Nik Middleton wrote:
As I understand it, a new ‘feature’ was added over the weekend to
resolve NAT. If you’re firewall is not allowing ICMP then FS waits
until it times out. At this time there is no option to disable it.
Regards
From: [email protected] [mailto:[email protected]
] On Behalf Of Muhammad Shahzad
Sent: 02 June 2009 11:40
To: [email protected]
Subject: [Freeswitch-users] Freeswitch taking too long to start up
Hi,
I have just upgraded Freeswitch from svn revision 12432 to 13544. I
am using 32bit CentOS 5.3, "make current" command completes
successfully without any errors but when i start freeswitch it take
considerable time (roughly 90 - 120 seconds) to start up. During
this time no message is display on console. Once successfully
started, it works fine. However, this initial delay is really
annoying. Is there anyway to reduce/remove this delay?
Thank you.
--
Muhammad Shahzad
-----------------------------------
CISCO Rich Media Communication Specialist (CRMCS)
CISCO Certified Network Associate (CCNA)
Cell: +92 334 422 40 88
MSN: [email protected]
Email: [email protected]
_______________________________________________
Freeswitch-users mailing list
[email protected]
http://lists.freeswitch.org/mailman/listinfo/freeswitch-users
UNSUBSCRIBE:http://lists.freeswitch.org/mailman/options/freeswitch-users
http://www.freeswitch.org
_______________________________________________
Freeswitch-users mailing list
[email protected]
http://lists.freeswitch.org/mailman/listinfo/freeswitch-users
UNSUBSCRIBE:http://lists.freeswitch.org/mailman/options/freeswitch-users
http://www.freeswitch.org
