We already send a 100 before the call even hits the dialplan. Mike
On Jun 5, 2009, at 8:00 PM, "Jim Burke" <[email protected]> wrote: > Could it be that you are getting several INVITE messages per call > due to 100 Trying message is not being sent until after the route is > selected from your java routing script? > > You might be able to send a 100 trying from your dialplan or script. > Keep in mind that this message stops timers on the originating side. > > - original message - > Subject: Re: [Freeswitch-users] Freeswitch creating more then two > sessions for one call > From: Michael Jerris <[email protected]> > Date: 05/06/2009 20:27 > > > On Jun 5, 2009, at 4:11 PM, Shoaib Khanzada wrote: > >> Thanks for the reply…. >> >> I was not running it for testing purpose because I’ve completed all >> testing successfully. >> >> We are running freeswitch in a voip carrier grade environment. It >> works perfectly alright in off peak hours when we have low calls >> ratio around 100-150 concurrent calls. However, in peak hours this >> goes beyond 200 calls and on that point freeswitch start creating >> many sessions for each calls. I have seen the sessions using >> “status” command and calls using “show calls count”. >> >> We are using javascript to select the route from the mysql database >> for each call. Could it be because script is taking longer than >> expected amount of time to retrieve a route? and freeswitch >> continuously keep creating sessions for incoming calls. That’s why I >> see low no of connected calls (if ‘show calls count’ only display >> the connected calls) whereas sessions are continuously being created >> by freeswitch as it is receiving many calls. >> >> If above text confuses you, nevermind just answer the following >> questions. >> >> 1) Does ‘show calls count’ display the connected calls only? > > Only bridged calls (2 sessions) > >> 2) When freeswitch create session instances? Before bridge or >> after bridge? Or one before bridge and one after bridge? > > It creates a session when it gets an incomming call and creates one > for each outgoing call, unrelated to bridging. > >> >> Thanks, >> >> Shoaib > > How are you doing the bridge in your script? Are you setting a var > then dropping out of the js to do the bridge? Can you post your js > file? > > Mike > > > > _______________________________________________ > Freeswitch-users mailing list > [email protected] > http://lists.freeswitch.org/mailman/listinfo/freeswitch-users > UNSUBSCRIBE:http://lists.freeswitch.org/mailman/options/freeswitch-users > http://www.freeswitch.org > > > _______________________________________________ > Freeswitch-users mailing list > [email protected] > http://lists.freeswitch.org/mailman/listinfo/freeswitch-users > UNSUBSCRIBE:http://lists.freeswitch.org/mailman/options/freeswitch-users > http://www.freeswitch.org _______________________________________________ Freeswitch-users mailing list [email protected] http://lists.freeswitch.org/mailman/listinfo/freeswitch-users UNSUBSCRIBE:http://lists.freeswitch.org/mailman/options/freeswitch-users http://www.freeswitch.org
