I know sangoma is working on their new pri stack, maybe it has proper qsig support. The openzap isdn stack does not right now and I was under the impression that the libpri support was pretty limited, but have no direct knowledge there.
Mike On Aug 13, 2009, at 3:34 PM, Ryan Wagoner wrote: > I've been trying to bridge FreeSWITCH with a Toshiba CIX using qsig > over a PRI. I have a Sangoma A102 card installed in a Dell PowerEdge > with CentOS 5.3. The issue I am having is no packets are being > transmitted back to FreeSWITCH. ifconfig w1g1 shows every frame > received as an overrun. I've tried a different server with CentOS 5.3 > with the same issue. I have a support ticket in with Sangoma, but was > wondering if anybody had seen this before. > > The T1 shows connected so I think I have the Toshiba configured > properly. From what I've read the overrun has to deal with the driver > not reading the data in time so maybe this is a CentOS 5.3 specific > issue. Any recommendations on alternative Linux distros known to work > with the Sangoma A102 card? > > Thanks, > Ryan > > [r...@voip ~]# ifconfig w1g1 > w1g1 Link encap:Point-to-Point Protocol > UP POINTOPOINT RUNNING NOARP MTU:80 Metric:1 > RX packets:22298 errors:0 dropped:0 overruns:274 frame:274 > TX packets:22298 errors:0 dropped:0 overruns:0 carrier:0 > collisions:0 txqueuelen:100 > RX bytes:1783840 (1.7 MiB) TX bytes:1783840 (1.7 MiB) > Interrupt:169 Memory:f8e80000-f8e81fff > > > [r...@voip ~]# wanrouter status > > Devices currently active: > wanpipe1 > > > Wanpipe Config: > > Device name | Protocol Map | Adapter | IRQ | Slot/IO | If's | CLK | > Baud rate | > wanpipe1 | N/A | A101/1D/A102/2D/4/4D/8| 169 | 4 | 1 > | N/A | 0 | > > Wanrouter Status: > > Device name | Protocol | Station | Status | > wanpipe1 | AFT TE1 | N/A | Connected | > > > [r...@voip ~]# wanpipemon -i w1g1 -c Ta > > ***** w1g1: T1 Alarms (Framer) ***** > > ALOS: OFF | LOS: OFF > RED: OFF | AIS: OFF > RAI: OFF | OOF: OFF > > ***** w1g1: T1 Alarms (LIU) ***** > > Short Circuit: OFF > Open Circuit: OFF > Loss of Signal: OFF > > > ***** w1g1: T1 Performance Monitoring Counters ***** > > Line Code Violation : 45 > Bit Errors (CRC6/Ft/Fs) : 0 > Out of Frame Errors : 0 > > > Rx Level : > -2.5db _______________________________________________ FreeSWITCH-users mailing list [email protected] http://lists.freeswitch.org/mailman/listinfo/freeswitch-users UNSUBSCRIBE:http://lists.freeswitch.org/mailman/options/freeswitch-users http://www.freeswitch.org
