Try configuring with 768x576; I've never had much luck with 800x600 on my setup. The messages from matroxfb seem to happen anyway, because the actual resolution is 720, but it seems to work ok because of the overscan.
Aubin On Fri, Feb 28, 2003 at 07:17:05PM -0500, Michael Ruelle wrote: > Ok I am having a problem running freevo on a non X framebuffer console. > > I have installed mga_vid from the Mplayer source. > I have the alias line in my /etc/modules.conf > > I did a freevo setup --display=mga (setup was previously xv using X11 > framebuffer) > > I can use freevo/fbcon/mga-ntsc-800-600.sh and get a good test console > that fills up the screen. > > but when I start freevo. > > I get a bunch of lines from matroxfb > which state a problem with an xres of 800 rounded up (not unusual i have > seen these before and the console is fine.) > > Then i get two pairs of line complaining about a 720 xres one time it > says rounded up to 768 the other it says 736. > > then freevo comes up but there is a big section of black on the right > side. like it must have used a 720 xres mode. > > Did i forget a step? > > Mike Ruelle > [EMAIL PROTECTED] > > > > > ------------------------------------------------------- > This sf.net email is sponsored by:ThinkGeek > Welcome to geek heaven. > http://thinkgeek.com/sf > _______________________________________________ > Freevo-users mailing list > [EMAIL PROTECTED] > https://lists.sourceforge.net/lists/listinfo/freevo-users ------------------------------------------------------- This sf.net email is sponsored by:ThinkGeek Welcome to geek heaven. http://thinkgeek.com/sf _______________________________________________ Freevo-users mailing list [EMAIL PROTECTED] https://lists.sourceforge.net/lists/listinfo/freevo-users
