Hi,
the problem is the big image. If you use squashfs-overlay, you need
at least 5 flash bocks free space for the jffs2 data partition,
where the overlay data is kept permanently. This means on your
system, you need 5*64kb free space. 3.3 MB is to big. 3.0 is save,
3.1 is nearly maximum. Check with df -h on the device.
Check the free space of the data partition.
bye
Waldemar
On Sun, 01 Jul 2007 at 18:39 +0200, [EMAIL PROTECTED] wrote:
>
> On Sun, 1 Jul 2007 18:23:52 +0200, Przemyslaw Kujawski
> <[EMAIL PROTECTED]> wrote:
> > On 17:24 Sun 01 Jul , [EMAIL PROTECTED] wrote:
> >> last night I have build a new freewrt image including bind for dns for
> > my
> >> linksys router. I have installed the image with mtd and reboot my
> > router.
> >> After reboot I logged in and want to change the directory to /etc.
> >
> > I had the same problem on my WRT54GL some time ago. NVRAM erase was the
> > solution in that case.
> >
>
> Hi Przemyslaw,
>
> thanks for advise. I will try it next weekend when I´m at home again and
> report my attempt.
>
> Do wiedzienia
>
> _______________________________________________
> freewrt-users mailing list
> freewrt-users@freewrt.org
> https://www.freewrt.org/lists/listinfo/freewrt-users
--
All embedded development kits suck. This one just sucks less.
http://www.freewrt.org
_______________________________________________
freewrt-users mailing list
freewrt-users@freewrt.org
https://www.freewrt.org/lists/listinfo/freewrt-users
