Is there a paragraph tag-command to variably change the column default of a text box from 1 column to two then back to 1 within the text box itself.
Background, I need to build two variable length tables that may overflow into multiple pages. The first table stretches across the entire page. The second table, which spans a little less than half the page width and needs to wrap into a second column when necessary before overflowing to an additional page, must start on the next line after the first table ends. Building the two tables is no problem - even allowing for the variable length of each and the wrapping feature of the second table. But I'm having a problem putting a the 1 and 2 column pieces together in the same text box. I can set the text box to do multtple columns, but that affects the entire text box and thus messes up the first table that spans the entire page. I tried doing this with two Template Pages (a 1 column and a 2 column) with Overflow Pages (again a 1 column and a 2 column) tied to the text box placed on each respective Tamplet Page to allow for tables that might overflow into other pages. When I composed this scenario, I get an error message that states... "The specified Keep conditions could not be honored in the flow <TableOne>. Text is truncated." And no text at all shows up. I get the correct amount of pages, just no text on them. Q1. What is the error message referring to? Q2. Can a text box on a Template Page be tied to another text box on an Overflow Page? Q3. Is there a way to switch from a single column text box to a multi-column and later back to a single column again? Thanks, David A. Sweet HKM Direct Market Communications +-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+- Calling all FP Web Users! Do you have a question or lots of knowledge to share about FusionPro Web? If so, join our Printable Web to Print Users' Forum today! Send email to [EMAIL PROTECTED] to find out how! +-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+- -- Users of FusionPro Desktop have unlimited free email support. Contact Printable Support at [EMAIL PROTECTED] -- View FusionPro Knowledge Base, FusionPro Samples at www.printable.com/vdp/desktop.htm -- You are currently subscribed to fusionpro as: [EMAIL PROTECTED] To unsubscribe send a blank email to [EMAIL PROTECTED] -- -- Note: All e-mail sent to or from this address will be received or otherwise recorded by the e-mail recipients of this forum. It is subject to archival, monitoring or review by, and/or disclosure to someone other than the recipient. Our privacy policy is posted on www.printplanet.com --
