On Tue, 09 Oct 2007 12:47:16 -0400, "Steve Blatman" <[EMAIL PROTECTED]> said: > We have a job that bleeds, but it's the kind of bleed you can set up > as butt cuts (name tags with a wide stripe across the top & bottom, > with type reversed out of it). Any thoughts on how to get Fusion Pro > to impose this with bleeds at the edges of the imposed sheet, but > without bleed gutters (and also without fine white lines at the cuts) > in the middle? >
You can remove a gutter and butt two pieces together in FPImposer. Try right clicking (PC) or single clicking (Mac) on the diagram to remove gutters for a chop cut. Regards, Brian +-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+- Calling all FP Web Users! Do you have a question or lots of knowledge to share about FusionPro Web? If so, join our Printable Web to Print Users' Forum today! Send email to [EMAIL PROTECTED] to find out how! +-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+- -- Users of FusionPro Desktop have unlimited free email support. Contact Printable Support at [EMAIL PROTECTED] -- View FusionPro Knowledge Base, FusionPro Samples at www.printable.com/vdp/desktop.htm -- You are currently subscribed to fusionpro as: [EMAIL PROTECTED] To unsubscribe send a blank email to [EMAIL PROTECTED] -- -- Note: All e-mail sent to or from this address will be received or otherwise recorded by the e-mail recipients of this forum. It is subject to archival, monitoring or review by, and/or disclosure to someone other than the recipient. Our privacy policy is posted on www.printplanet.com --
