Has anyone experienced this (yet)? When exporting a Fusion Pro document (with bleed) out of Quark 7 and then composing that document using an FP Imposer imposition file, the bleed comes out wrong -- specifically, the marks will be in the right place, but the page image will be shifted up and to the left for the distance of the bleed settings.
A less-than-elegant workaround works as such: 1. When you Export your document to Fusion Pro and you are prompted to name the exported file, enter "0" in the lower lefthand corner under "Bleed" box. 2. Continue on until Fusion Pro asks you for your data file. At this point, click the Cancel button. Close the Fusion Pro PDF that was created (you can choose to save it or not save it, it doesn't matter). 3. Go back to the Quark document and start the Fusion Pro Export over again. This time, enter the correct Bleed amount in the Bleed box when prompted to name your exported file. Resave it over the old version, and choose "No" if asked to retain paragraph styles, colors, etc. 4. Proceed as normal. The bleeds should work as expected. For some reason, it seems like starting off with "0" for Bleed resets the bleed settings, and then sets the stage for entering the correct bleed amount and yielding the right results. Note: the following issue did NOT occur when exporting to FusionPro from InDesign. This only seems to happen when exporting from Quark 7. This worked normally when using the 4.xx versions of Fusion Pro and Quark 6.5, so I'm not sure which is to blame. Can anyone shed any light on this? Thanks, -Joe Ochwat +-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+- FusionPro 5.0 Now Available! Variable text on a curve and soft drop-shadows for variable text LIMITED TIME upgrade offer of $299 per license for current customers: http://fusionpro.printable.com/store/upgrade New licenses available for $599 each at: http://fusionpro.printable.com/store/ All FusionPro 5.0 customers to receive FusionPro 5.1 with Adobe Acrobat 8 and InDesign CS3 support when released for FREE. +-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+- -- Users of FusionPro Desktop have unlimited free email support. Contact Printable Support at [EMAIL PROTECTED] -- View FusionPro Knowledge Base, FusionPro Samples at www.printable.com/vdp/desktop.htm -- You are currently subscribed to fusionpro as: [EMAIL PROTECTED] To unsubscribe send a blank email to [EMAIL PROTECTED] -- -- Note: All e-mail sent to or from this address will be received or otherwise recorded by the e-mail recipients of this forum. It is subject to archival, monitoring or review by, and/or disclosure to someone other than the recipient. Our privacy policy is posted on www.printplanet.com --
