I have received no helpful responses to my query from several days ago so I thought I would post again hoping most specifically for feedback from Printable tech staff. I have been using your Desktop software for almost 2 years and Imposer since you released it. I have had no problems creating templates to correctly impose for cut & stack postcard runs on my iGen until I recently upgraded from 3.2 to 4.1. When I edit the template the numbers correctly display by record number based on my stack count entered, but when the job composes it simply prints recs 1-8, 8-16 etc per sheet for an 8-up 4X2 run. I'm at a critical point here with my management and need some help immediately. Thanks in advance, Geoff
-- Users of FusionPro Desktop have unlimited free email support. Contact Printable Support at [EMAIL PROTECTED] -- View FusionPro Knowledge Base, FusionPro Samples at www.printable.com/vdp/desktop.htm -- You are currently subscribed to fusionpro as: [email protected] To unsubscribe send a blank email to [EMAIL PROTECTED] -- -- Note: All e-mail sent to or from this address will be received or otherwise recorded by the e-mail recipients of this forum. It is subject to archival, monitoring or review by, and/or disclosure to someone other than the recipient. Our privacy policy is posted on www.printplanet.com --
