We just ran our first FusionPro job and it worked! but we have the following issue:
In FusionPro we can compose a file as a PDF, send it to our Creo CXP5000/Xerox DocuColor 2045, and it shows up in the proper landscape orientation and prints fine. If we compose the same file as a Single-File VPS it shows up on the Creo in Portrait orientation and has to be rotated at the Creo before printing. 1. Why does page orientation change for VPS files? Where in FusionPro can we check and correct page orientation? 2. When we compose a Single-File VPS we get a file with the extension .vps. Page 257 of the FusionPro manual says we should get the extension .zip and that .vps is for Multi-file VPS. Which is right? Were running OSX 10.4.8, Acrobat 7.0.9, and FusionPro 4.1.6 Any guidance would be appreciated. Julian Hearne Aljon Graphics -- Users of FusionPro Desktop have unlimited free email support. Contact Printable Support at [EMAIL PROTECTED] -- View FusionPro Knowledge Base, FusionPro Samples at www.printable.com/vdp/desktop.htm -- You are currently subscribed to fusionpro as: [email protected] To unsubscribe send a blank email to [EMAIL PROTECTED] -- -- Note: All e-mail sent to or from this address will be received or otherwise recorded by the e-mail recipients of this forum. It is subject to archival, monitoring or review by, and/or disclosure to someone other than the recipient. Our privacy policy is posted on www.printplanet.com --
