On Jul 10, 2007, at 12:00 PM, [EMAIL PROTECTED] wrote:
Does the fusion pro imposer have the ability to do a dutch cut
imposition?
The FP Imposer user guide seems very limited with information. thanks!
Its my understanding Dutch Cut is where you have 3-up with one page
positioned vertically at the end of where two pages of the same size
meet horizontally. If this is correct, no, FP Imposer will not do
this at this time. You can rotate an individual page but there is no
way to create an odd numbered layout and offset the page.
You will probably have to create an imposition manually or find some
clever way to run imposition twice.
Regards,
Brian Ray
+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-
Calling all FP Web Users!
Do you have a question or lots of knowledge to share about FusionPro Web?
If so, join our Printable Web to Print Users' Forum today!
Send email to [EMAIL PROTECTED] to find out how!
+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-
--
Users of FusionPro Desktop have unlimited free email support. Contact Printable Support at [EMAIL PROTECTED]
--
View FusionPro Knowledge Base, FusionPro Samples at
www.printable.com/vdp/desktop.htm
--
You are currently subscribed to fusionpro as: [EMAIL PROTECTED]
To unsubscribe send a blank email to [EMAIL PROTECTED]
--
--
Note: All e-mail sent to or from this address will be received or otherwise
recorded by the e-mail recipients of this forum. It is subject to archival,
monitoring or review by, and/or disclosure to someone other than the recipient.
Our privacy policy is posted on www.printplanet.com
--
