Good evening, Am 2009-03-10 16:38:48, schrieb Thomas Adam: > Then read up on the "-s" option to the FVWM binary in "man fvwm".
OK
> > Q 2: Does someone know, HOW to get the resolution of 1366x768? This
> > pig of "xserver-xorg-video-mga" switch always back to 1280x800
>
> Are you sure that's a valid modeline for this card? (Look at
> /var/log/Xorg.0.log for all of that information.)
It tell me always:
----[ '/var/log/Xorg.0.log' ]-------------------------------------------
<snip>
(==) ServerLayout "Default Layout"
(**) |-->Screen "Screen VW161D" (0)
(**) | |-->Monitor "Asus VW161D"
(**) | |-->Device "Matrox G450 DualHead VW161D"
(**) |-->Screen "Screen AAC15" (1)
(**) | |-->Monitor "LiteOn AAC15"
(**) | |-->Device "Matrox G450 DualHead AAC15"
(**) |-->Input Device "Generic Keyboard"
(**) |-->Input Device "Configured Mouse"
(**) Option "Xinerama" "true"
<snip>
(**) Xinerama: enabled
<snip>
(--) PCI:*(1:0:0) Matrox Graphics, Inc. MGA G400/G450 rev 130, Mem @
0xfa000000/25, 0xf9000000/14, 0xf8800000/23, BIOS @ 0xf9fe0000/17
<snip>
(II) MGA: driver for Matrox chipsets: mga2064w, mga1064sg, mga2164w,
mga2164w AGP, mgag100, mgag100 PCI, mgag200, mgag200 PCI,
mgag200 SE A PCI, mgag200 SE B PCI, mgag200 Maxim, mgag200 Winbond,
mgag400, mgag550
(II) Primary Device is: PCI 01:00:0
(--) Chipset mgag400 found
(--) Chipset mgag400 found
<snip>
(II) Setting vga for screen 0.
(II) Setting vga for screen 1.
(II) Loading sub module "vgahw"
(II) LoadModule: "vgahw"
(II) Loading /usr/lib/xorg/modules//libvgahw.so
(II) Module vgahw: vendor="X.Org Foundation"
compiled for 1.4.2, module version = 0.1.0
ABI class: X.Org Video Driver, version 2.0
(--) MGA(0): Chipset: "mgag400" (G450)
(**) MGA(0): Depth 24, (--) framebuffer bpp 32
(==) MGA(0): RGB weight 888
(**) MGA(0): Option "UseFBDev" "false"
(==) MGA(0): Using AGP 1x mode
(==) MGA(0): Using HW cursor
(==) MGA(0): Using XAA acceleration
(--) MGA(0): Linear framebuffer at 0xFA000000
(==) MGA(0): MMIO registers at 0xF9000000
(--) MGA(0): Pseudo-DMA transfer window at 0xF8800000
(--) MGA(0): BIOS at 0xF9FE0000
(II) Attempted to read BIOS 128KB from /sys/bus/pci/devices/0000:01:00.0/rom:
got 34KB
(--) MGA(0): Video BIOS info block at offset 0x07720
(==) MGA(0): Removed MMIO write-combining range (0xfa800000,0x800000)
(==) MGA(0): Removed MMIO write-combining range (0xfa800000,0x800000)
(==) MGA(0): Removed MMIO write-combining range (0xfa000000,0x800000)
(==) MGA(0): Write-combining range (0xfa000000,0x2000000)
(--) MGA(0): Crtc2 will use 8192K of VideoRam
(--) MGA(0): VideoRAM: 8192 kByte
(II) Loading sub module "ddc"
(II) LoadModule: "ddc"(II) Module "ddc" already built-in
(II) Loading sub module "i2c"
(II) LoadModule: "i2c"(II) Module "i2c" already built-in
(==) MGA(0): Write-combining range (0xfa000000,0x800000)
(II) MGA(0): vgaHWGetIOBase: hwp->IOBase is 0x03d0, hwp->PIOOffset is 0x0000
(II) MGA(0): I2C bus "DDC P1" initialized.
(II) MGA(0): I2C device "DDC P1:ddc2" registered at address 0xA0.
(II) MGA(0): I2C device "DDC P1:ddc2" removed.
(II) MGA(0): I2C Monitor info: (nil)
(II) MGA(0): end of I2C Monitor info
(--) MGA(0): No DDC signal
(II) MGA(0): DDC Monitor info: (nil)
(II) MGA(0): end of DDC Monitor info
<snip>
(II) MGA(0): VESA BIOS detected
(II) MGA(0): VESA VBE Version 3.0
(II) MGA(0): VESA VBE Total Mem: 16384 kB
(II) MGA(0): VESA VBE OEM: Matrox Graphics Inc.
(II) MGA(0): VESA VBE OEM Software Rev: 1.2
(II) MGA(0): VESA VBE OEM Vendor: Matrox
(II) MGA(0): VESA VBE OEM Product: Matrox G450
(II) MGA(0): VESA VBE OEM Product Rev: 00
(II) Loading sub module "ddc"
(II) LoadModule: "ddc"(II) Module "ddc" already built-in
(II) MGA(0): VESA VBE DDC supported
(II) MGA(0): VESA VBE DDC Level none
(II) MGA(0): VESA VBE DDC transfer in appr. 0 sec.
(II) MGA(0): VESA VBE DDC read failed
(==) MGA(0): Using gamma correction (1.0, 1.0, 1.0)
(==) MGA(0): Min pixel clock is 17 MHz
(--) MGA(0): Max pixel clock is 800 MHz
(II) MGA(0): Asus VW161D: Using hsync range of 28.00-50.00 kHz
(II) MGA(0): Asus VW161D: Using vrefresh range of 43.00-75.00 Hz
(II) MGA(0): Clock range: 17.75 to 800.00 MHz
(II) MGA(0): Not using mode "1368x768_75.00" (hsync out of range)
<snip>
83 modes
<snip>
(II) MGA(0): Not using mode "1368x768_75.00" (no mode of this name)
(--) MGA(0): Has SDRAM
(--) MGA(0): Virtual size is 1280x800 (pitch 1280)
(**) MGA(0): Default mode "1280x800": 83.5 MHz, 49.7 kHz, 60.0 Hz
(II) MGA(0): Modeline "1280x800"x60.0 83.46 1280 1344 1480 1680 800 801 804
828 (49.7 kHz)
(**) MGA(0): Default mode "1280x768": 80.1 MHz, 47.7 kHz, 60.0 Hz
(II) MGA(0): Modeline "1280x768"x60.0 80.14 1280 1344 1480 1680 768 769 772
795 (47.7 kHz)
I will try this one too since it is better then the current crap...
<snip>
(II) Loading sub module "ddc"
(II) LoadModule: "ddc"(II) Module "ddc" already built-in
(II) Loading sub module "i2c"
(II) LoadModule: "i2c"(II) Module "i2c" already built-in
(==) MGA(1): Write-combining range (0xfa800000,0x800000)
(II) MGA(1): vgaHWGetIOBase: hwp->IOBase is 0x03d0, hwp->PIOOffset is 0x0000
(II) MGA(1): I2C bus "DDC P2" initialized.
(II) MGA(1): I2C bus "MAVEN" initialized.
(II) MGA(1): Failed to register MGA-TVO I2C device!
(II) MGA(1): I2C device "DDC P2:ddc2" registered at address 0xA0.
(II) MGA(1): I2C Monitor info: 0x8b6c708
(II) MGA(1): Manufacturer: LTN Model: 22c Serial#: 16843009
(II) MGA(1): Year: 2004 Week: 43
(II) MGA(1): EDID Version: 1.3
(II) MGA(1): Analog Display Input, Input Voltage Level: 0.700/0.700 V
(II) MGA(1): Sync: Separate
(II) MGA(1): Max H-Image Size [cm]: horiz.: 30 vert.: 23
(II) MGA(1): Gamma: 2.20
(II) MGA(1): DPMS capabilities: Off; RGB/Color Display
(II) MGA(1): First detailed timing is preferred mode
(II) MGA(1): redX: 0.643 redY: 0.344 greenX: 0.304 greenY: 0.566
(II) MGA(1): blueX: 0.141 blueY: 0.085 whiteX: 0.312 whiteY: 0.318
(II) MGA(1): Supported VESA Video Modes:
(II) MGA(1): 720x...@70hz
(II) MGA(1): 640x...@60hz
(II) MGA(1): 640x...@67hz
(II) MGA(1): 640x...@72hz
(II) MGA(1): 640x...@75hz
(II) MGA(1): 800x...@56hz
(II) MGA(1): 800x...@60hz
(II) MGA(1): 800x...@72hz
(II) MGA(1): 800x...@75hz
(II) MGA(1): 832x...@75hz
(II) MGA(1): 1024x...@60hz
(II) MGA(1): 1024x...@70hz
(II) MGA(1): 1024x...@75hz
(II) MGA(1): Manufacturer's mask: 0
(II) MGA(1): Supported additional Video Mode:
(II) MGA(1): clock: 65.0 MHz Image Size: 304 x 228 mm
(II) MGA(1): h_active: 1024 h_sync: 1048 h_sync_end 1184 h_blank_end 1344
h_border: 0
(II) MGA(1): v_active: 768 v_sync: 771 v_sync_end 777 v_blanking: 806
v_border: 0
(II) MGA(1): Ranges: V min: 55 V max: 76 Hz, H min: 30 H max: 61 kHz,
PixClock max 80 MHz
(II) MGA(1): Monitor name: M15AAQ/C
<snip>
(--) MGA(1): Virtual size is 1024x768 (pitch 1024)
(**) MGA(1): *Driver mode "1024x768": 65.0 MHz, 48.4 kHz, 60.0 Hz
(II) MGA(1): Modeline "1024x768"x60.0 65.00 1024 1048 1184 1344 768 771 777
806 -hsync -vsync (48.4 kHz)
(**) MGA(1): Display dimensions: (300, 230) mm
(**) MGA(1): DPI set to (86, 84)
<snip>
------------------------------------------------------------------------
and:
[michelle.konz...@michelle1:~] gtf 1366 768 75
# 1368x768 @ 75.00 Hz (GTF) hsync: 60.15 kHz; pclk: 110.19 MHz
Modeline "1368x768_75.00" 110.19 1368 1456 1600 1832 768 769 772 802
-HSync +Vsync
[michelle.konz...@michelle1:~] cvt 1366 768 75
# 1368x768 74.90 Hz (CVT) hsync: 60.30 kHz; pclk: 109.50 MHz
Modeline "1368x768_75.00" 109.50 1368 1448 1592 1816 768 771 781 805 -hsync
+vsync
[michelle.konz...@michelle1:~] cvt 1366 768
# 1368x768 59.88 Hz (CVT) hsync: 47.79 kHz; pclk: 85.25 MHz
Modeline "1368x768_60.00" 85.25 1368 1440 1576 1784 768 771 781 798 -hsync
+vsync
Which mean, that 'gtv' and 'cvt' do not accept 1366 as width.
Thanks, Greetings and nice Day/Evening
Michelle Konzack
Systemadministrator
24V Electronic Engineer
Tamay Dogan Network
Debian GNU/Linux Consultant
--
Linux-User #280138 with the Linux Counter, http://counter.li.org/
##################### Debian GNU/Linux Consultant #####################
<http://www.tamay-dogan.net/> Michelle Konzack
<http://www.can4linux.org/> Apt. 917
<http://www.flexray4linux.org/> 50, rue de Soultz
Jabber [email protected] 67100 Strasbourg/France
IRC #Debian (irc.icq.com) Tel. DE: +49 177 9351947
ICQ #328449886 Tel. FR: +33 6 61925193
signature.pgp
Description: Digital signature
