I have ISP Redundancy configured on my FW, I use one DSL line with Cisco Router and another one with PPPOE DSL Modem. I use Load Sharing configuration. The status of my both connections is ok, but I see that all the traffics goes via my first connection and no traffic goes to my second modem. When I power off my router on the first line all the traffic goes to the second line, but when I power on the router again all the traffic goes there and my second line "dies" again. Also if I switch my firewall to Primary/Backup configuration and setup my second line as primary it works fine. Any ideas how can I make this two lines work together ? Thank you.
<http://100273.sigclick.mailinfo.com/sigclick/03050201/07024F04/0B490022 523013.jpg> ================================================= To set vacation, Out-Of-Office, or away messages, send an email to [EMAIL PROTECTED] in the BODY of the email add: set fw-1-mailinglist nomail ================================================= To unsubscribe from this mailing list, please see the instructions at http://www.checkpoint.com/services/mailing.html ================================================= If you have any questions on how to change your subscription options, email [EMAIL PROTECTED] =================================================
