Markus Schmidt a écrit :
Hi,
I've installed the R61 HFA_02 on my Smart Center and on the standby
Cluster node.
However, I'm not able to connect anymore to that Clusternode via ssh
from my SmartCenter. The Policy allows that connection, and I can see it
as allowed in the SmartTracker, also.
In addition, I'm able to connect to that Clusternode via ssh from the
other (active) Clusternode, wich runs without HFA_02 so far.
If I disable the policy, or remove the HFA_02 from my standby Cluster, I
can connect to him as expected.
Anyone seen such a behaviour?
hello,
did you check with a tcpdump if the ssh connection from the smartcenter
was fine ?
check in the /etc/ssh/sshd_config that the daemon listen to all the IPs
(ListenAddress parameter).
confirm with a netstat -an.
the ssh is already configured to log, so run "grep -w sshd
/var/log/messages" to see if there
is any entry that match the connection you tried to initialize.
regards, Markus
=================================================
To set vacation, Out-Of-Office, or away messages,
send an email to [EMAIL PROTECTED]
in the BODY of the email add:
set fw-1-mailinglist nomail
=================================================
To unsubscribe from this mailing list,
please see the instructions at
http://www.checkpoint.com/services/mailing.html
=================================================
If you have any questions on how to change your
subscription options, email
[EMAIL PROTECTED]
=================================================
