Felipe Almeida a écrit :
Well, I did that for the FTP. Created a new TCP service with the port 21
and didn't assign any protocol type to it. After that, I am able to
connect to my FTP, but after any command (for example, dir, ls -la, put),
it shows "200 PORT command successful" and doesn't show any results. Stay
like that until I get a time out.
do you know about ftp active and passive modes ?
this is also part of smartdefense to dinamically open the data port for
ftp connections.
I don't have any protocol associated with that port. And I also selected a
profile in SmartDefense and deactivated all the available protections.
This error isn't being shown in my SmartDefense log.
Things here are getting too much strange.
can you switch from ftp to scp ?
Scanned by Check Point Total Security Gateway.
=================================================
To set vacation, Out-Of-Office, or away messages,
send an email to [EMAIL PROTECTED]
in the BODY of the email add:
set fw-1-mailinglist nomail
=================================================
To unsubscribe from this mailing list,
please see the instructions at
http://www.checkpoint.com/services/mailing.html
=================================================
If you have any questions on how to change your
subscription options, email
[EMAIL PROTECTED]
=================================================
