I had a similar issue once, quite a while ago, I believe with R65. Never found an answer and had a case opened with Check Point support for months with no resolution.
At the end, the customer needed to change hardware and I did a clean install, so the issue went away with the old box. Regards On Fri, May 18, 2012 at 8:38 AM, Liu, Huiqi <[email protected]>wrote: > Hello All, > > I have a problem with connecting to our enforcement with WebUI. It seems > to have started since I did some internal network changes, and re-IPed one > of the interfaces, though it could have been there earlier. > > IE just says "Internet Explorer cannot display the webpage", ssh access to > the box is fine. > > Rule base looks OK as I can see the traffic being accepted, and httpd is > running. > > Have anyone seen similar problems? > > Many thanks! > > Huiqi Liu > > ================================================= > To set vacation, Out-Of-Office, or away messages, > send an email to [email protected] > in the BODY of the email add: > set fw-1-mailinglist nomail > ================================================= > To unsubscribe from this mailing list, > please see the instructions at > http://www.checkpoint.com/services/mailing.html > ================================================= > If you have any questions on how to change your > subscription options, email > [email protected] > ================================================= > -- Sergio Alvarez CISSP | CCSE+ ================================================= To set vacation, Out-Of-Office, or away messages, send an email to [email protected] in the BODY of the email add: set fw-1-mailinglist nomail ================================================= To unsubscribe from this mailing list, please see the instructions at http://www.checkpoint.com/services/mailing.html ================================================= If you have any questions on how to change your subscription options, email [email protected] =================================================
