If it is just 2 specific addresses you could create workstation objects for them, make them external then either use them in a rule or put them in a group and use the group in a rule allowing the service.
-PaulK
*********************************************
Paul Keser
Network Security Engineer
[EMAIL PROTECTED]
tel: 415.351.4037
fax: 415.474.6017
ShopExpert.com
1375 Sutter Street, Suite 400
San Francisco, CA 94109
*********************************************
> -----Original Message-----
> From: Carlos Madrid [mailto:[EMAIL PROTECTED]]
> Sent: Tuesday, May 23, 2000 9:18 AM
> To: [EMAIL PROTECTED]
> Subject: [FW1] Specific Port/Specific IP
>
>
>
> Does anyone know of a way to allow two (2) specific ip address
> through a specific port? I may have a requirement to open port
> XXXX for IPs XXX.XXX.XXX.XXX to a specific machine, w/o being
> able to install any software for VPN/PPTP.
>
> > Pls determine if it's possible to allow traffic
> > to that IP address on that port only
>
> Thanks in advance!
>
> Carlos P. Madrid
> Systems Administrator
> High Technology Solutions, Inc.
> [EMAIL PROTECTED]
> tel: +1-858-495-0508
> fax: +1-858-495-0511
>
> "It's seldom possible to predict innovation,
> it's frequently possible to predict improvement."
> - Brian Clark
>
>
>
> ==============================================================
> ==================
> To unsubscribe from this mailing list, please see the
> instructions at
> http://www.checkpoint.com/services/mailing.html
> ==============================================================
> ==================
>
