It's possible - just did this exact configuration at a customer site
yesterday.
However you need version 4.1 SP1 and to configure Hybrid Mode IKE.
A PDF titled "Hybrid Mode IKE for SecuRemote Authentication" describe how
and is available at Check Point's new support site. (I can't give you an
exact
URL because the site is down again - for a change....)
Best regards,
Jacob Herbst
Dubex A/S
www.dubex.dk
-----Original Message-----
From: Gelson Dias Santos [mailto:[EMAIL PROTECTED]]
Sent: 30. maj 2000 21:13
To: [EMAIL PROTECTED]
Subject: [FW1] SecuRemote + ISAKMP + Radius?
My SecuRemote users authenticate through ISAKMP pre-shared secrets,
i.e., local passwords defined on the ISKMP Properties of the user. I would
like to authenticate it on a Radius server. Is that possible? Note I known
how to authenticate _the user_ on Radius; what i'm asking is how to
authenticate the user encryption used by SecuRemote. If I could do that, my
users would use the same login/password for remote dialup and securemote,
And I would not need to add all of them locally on the firewall.
Thanks,
Gelson
============================================================================
====
To unsubscribe from this mailing list, please see the instructions at
http://www.checkpoint.com/services/mailing.html
============================================================================
====
================================================================================
To unsubscribe from this mailing list, please see the instructions at
http://www.checkpoint.com/services/mailing.html
================================================================================
