Hello Francis,
on NT you are asked for a license key when you do the installation.
If you want to make an upgrade of your software you can use your
old licence no. This is only legal if you have a support contract.
But be careful:
I've upgraded from 3.32 to 3.4 on NT and the installation of 3.4 hat made
a complete new installation! If you want to use your settings in the new
version make a backup of interscan files and then you have to reenter
your old settings in the new intscan.ini. This worked for me on NT.
Olav
-----Original Message-----
From: THELLIER, Francis (Kedros) [mailto:[EMAIL PROTECTED]]
Sent: Monday, June 26, 2000 5:00 PM
To: '[EMAIL PROTECTED]'
Subject: [FW1] InterScan3.5 installation : Serial Number
Hello,
I've read the documentations to install a new version of InterScan : 3.5
version.
In this documentations I've read that at one point of the installation I
have to enter the serial number,
but where can I have it ? Can I put the same that I have before ? (I've
looked in /etc/iscan/intscan.ini where there is a serial number)
Thanks in advance,
> Francis THELLIER
>
============================================================================
====
To unsubscribe from this mailing list, please see the instructions at
http://www.checkpoint.com/services/mailing.html
============================================================================
====
================================================================================
To unsubscribe from this mailing list, please see the instructions at
http://www.checkpoint.com/services/mailing.html
================================================================================
