First, did you apply your access list for INBOUND or OUTbound traffic on
the interface?
Second, the access list is going to be read sequentially, from top to
bottom. Are you sure there isn't a rule above this one which is permitting
this traffic?
Lastly, once you apply an access list, there's an implied "deny all" at the
bottom. The only reason you need to add a deny statement, is to block a
subset which is getting through because of an earlier permit.
Good luck!
At 03:49 PM 7/29/00 +0700, [EMAIL PROTECTED] wrote:
>Dear All,
>
>I try to filer tcp port 264 and 265 from internet network with following
>configure but it not working.
>
>!
>interface Serial0
>ip address A.B.C.D 255.255.255.0
>ip access-group 110 in
>!
>access-list 110 deny tcp any any eq 264
>access-list 110 deny tcp any any eq 265
>
>Does anyone have any ideas, any thoughts would be much appreciated.
>
>Thank you very much.
>
>Prayut Suwanvisat
>New Network Engineer.
>----------------------------------------------------------------
>The information transmitted is intended only for the person or entity to which
>it is addressed and may contain confidential and/or privileged material. Any
>review, retransmission, dissemination or other use of, or taking of any action
>in reliance upon, this information by persons or entities other than the
>intended recipient is prohibited. If you received this in error, please
>contact the sender and delete the material from any computer.
>
>
>
>
>================================================================================
> To unsubscribe from this mailing list, please see the instructions at
> http://www.checkpoint.com/services/mailing.html
>================================================================================
>
-
"As soon as men decide that all
means are permitted to fight an evil,
their good becomes indistinguishable
from the evil they set out to destroy."
--Christopher Dawson
================================================================================
To unsubscribe from this mailing list, please see the instructions at
http://www.checkpoint.com/services/mailing.html
================================================================================
