Hello Herbert,
When you installed the Checkpoint software, did you choose the Backward
Compatibility mode which will allow it work with older pre-4.1 firewall
modules? I'm not sure what errors would occur without enabling this check
during installation (in your situation), but this may be the issue.
Regards,
Stephen
-----Original Message-----
From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED]]
Sent: Wednesday, August 16, 2000 3:58 PM
To: [EMAIL PROTECTED]
Subject: [FW1] Checkpoint-1 Remote Management Module Problem
Hi,
I've already asked a similar question once but got little help. Trying again
since the
whole matter is getting really frustrating.
I'm trying to set up a centralised Checkpoint-1 Management Console and three
firewall modules. The EMC is 4.1, whereas two modules are also 4.1 (running
on
NT/UNIX boxes) and the last one is a 3.0 module running on an ODS
PizzaSwitch.
I've managed to get the EMC to communicate with the two 4.1 modules with
little
difficulty. However, I just can't get the 3.0 module to authenticate itself
with
the EMC -
all I get are "log authentication failure" and "connection broken while
communication
with x.x.x.x for bloadme" messages on the switch.
Since the firewall module on the switch uses skey to authenticate, I've
tried
playing
around with the control.map file by replacing all occurrences of fwa1 with
skey.
Still,
the behaviour remained the same. I've tried all the normal tricks (ie.
re-entering the
key) several times - same behaviour throughout.
I'd love to hear from anyone who has managed to get a similar setup (at
least a
4.1
management with a 3.0 module) running.
Thanks,
Herbert
============================================================================
====
To unsubscribe from this mailing list, please see the instructions at
http://www.checkpoint.com/services/mailing.html
============================================================================
====
================================================================================
To unsubscribe from this mailing list, please see the instructions at
http://www.checkpoint.com/services/mailing.html
================================================================================
