OK, i`ll give it a go......
.....Just tried that and I`m still getting traffic with internal source
addresses :(
Steve
----- Original Message -----
From: "Ray Lodato" <[EMAIL PROTECTED]>
To: "'Steve Loughran'" <[EMAIL PROTECTED]>; "FW-1 Users"
<[EMAIL PROTECTED]>
Sent: Wednesday, September 06, 2000 2:25 PM
Subject: RE: [FW1] NAT isnt NATing (sometimes)
> I ran into a similar problem when I used the "Install On" column to
specify
> the firewalls I wanted the NAT rule on. I tend not to use the Automatic
> Translation rules, but manually define them. I realized that the policy
> would only be loaded on the two firewalls I had listed in the "Install On"
> column, so I changed it to All, and I haven't had a problem since.
>
> Ray Lodato
> NEF Information Services
> 617-578-3197
> [EMAIL PROTECTED]
================================================================================
To unsubscribe from this mailing list, please see the instructions at
http://www.checkpoint.com/services/mailing.html
================================================================================
