Ok,
Here is my setup
2 Locations with two different networks
Location A IP = 10.10.0.0 Subnet Mask 255.255.0.0
Location B IP = 10.15.0.0 Subnet Mask 255.255.0.0
Problem:
On my NT FW1 Box when the security policy is not loaded everything routes
fine I can ping the other network, they can ping through. As soon as I load
a security policy one of the networks will not route anymore.
My Setup is as follows
FW1 box:
EXT_Interface = x.x.20.0 Default Gateway = Next internet hop
INT_Interface - 10.10.20.1 No Default Gateway set, SUBNET MASK = 255.255.0.0
Routing table looks like this:
0.0.0.0 0.0.0.0 x.x.20.0
10.20.0.0 255.255.0.0 10.10.20.1
10.15.0.0 255.255.0.0 10.10.20.14 <----IP Address of internal router, This
is also a manual route addition...
I can not figure this one out any help would be appreciated...
THanks
Michael Mills
[EMAIL PROTECTED]
================================================================================
To unsubscribe from this mailing list, please see the instructions at
http://www.checkpoint.com/services/mailing.html
================================================================================
